Audiovox Incaar Systems GmbH D189070 Benutzerhandbuch
3
–
Press the retaining clips -arrowed-
inwards on both sides to release
the removal tools -1-.
inwards on both sides to release
the removal tools -1-.
–
Disconnect the harness connectors
-1- and remove the control unit -2-
from the vehicle.
-1- and remove the control unit -2-
from the vehicle.
Installation
Installation is the reverse of removal
procedure, noting the following.
procedure, noting the following.
–
Ensure all electrical connectors are
connected correctly prior to
installation.
connected correctly prior to
installation.
–
After installation ensure the
catches secure the control unit on
both sides. This can be confirmed
by an audible click being heard and
then attempting to withdraw the
control unit without using the
removal tools.
catches secure the control unit on
both sides. This can be confirmed
by an audible click being heard and
then attempting to withdraw the
control unit without using the
removal tools.
–
A new control unit will require
coding. Connect the Vehicle tester
to the vehicle and run Software
Version Management (SVM). Refer
to "Diagnostic system - Guided
functions/Component
replacement".
coding. Connect the Vehicle tester
to the vehicle and run Software
Version Management (SVM). Refer
to "Diagnostic system - Guided
functions/Component
replacement".
→ Rep.-Gr.97