Deadman Technologies LLC AV01RF Benutzerhandbuch
AV01-RF Manual
Deadman Technologies, LLC Transceiver Module
AV01-RF, version 0.1
AV01-RF is a wireless transceiver data module with reasonably small form factor, low power
consumption, good stability and reliability. It has wide application uses in remote control,
industry automation, wireless telemetry and remote consumer applications. This module has an
embedded micro-controller and is highly versatile with several General Purpose Input and
Output (GPIO) options for equipment and other devices’ connectivity.
AV01-RF is designed with Texas Instruments CC2510F32 transceiver chip with embedded
MCU. The module comes preprogrammed from the factory employing spread spectrum
diversity and compliant to FCC 15.241
Changes or modifications not expressly approved by Deadman Technologies, LLC could
void the user's authority to operate the equipment.
FCC
The following statement must be placed in the finish product users manual:
Changes or modifications not expressly approved by Deadman Technologies, LLC could void the
user's authority to operate the equipment.
user's authority to operate the equipment.
Or equivalently:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
void the user's authority to operate the equipment.
The following statement must be placed in the finish product users manual
:
“This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.”
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.”
The following statement is required to be placed on the product. If the product is too small, (defined by <4
x 4 inches) or if approved by the FCC, this statement may be placed in the manual.
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.”
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.”
The finished product label must state the following:
Contains FCC ID: 244KR-AV01RF
Contains IC: 11230A-AV01RF
Contains IC: 11230A-AV01RF
The FCC ID and/or IC certification numbers must be placed on a non-removable portion of the exterior of
the finished product. Contact Deadman Technologies, LLC for questions regarding placement of
certification numbers.
the finished product. Contact Deadman Technologies, LLC for questions regarding placement of
certification numbers.
1
For class B devices (intended for residential use), contact Deadman Technologies for changes to required statements.