Shanghai HowayGIS Co. Ltd T1XN2017 Benutzerhandbuch

Seite von 17
15 
9.
FCC Warnings
Any Changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment.   
This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 
(1)This 
device 
may 
not 
cause 
harmful 
interference, 
and  
(2) This device must accept any interference received, including interference that may cause 
undesired operation.   
ISED RSS Warning:
 
This device complies with Innovation,Science and Economic Development Canada licence-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device 
may not cause interference, and (2) this device must accept any interference, including 
interference that may cause undesired operation of the device. 
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio 
exempts de licence.   L'exploitation est autorisée aux deux conditions suivantes:   
(1) l'appareil ne doit pas produire de brouillage, et   
(2)  l'utilisateur  de  l'appareil  doit  accepter  tout  brouillage  radioélectrique  subi,  même 
si  le  brouillage est susceptible d'en compromettre le fonctionnement. 
This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:  
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver 
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.