Furrion Ltd DV1230 Benutzerhandbuch

17

In RADIO mode, press and hold the AM/FM  

button to select your desired frequency 

USA1/USA2/AUSTRALIA/EUROPE.

In RADIO mode, press the AM/FM button 

on the remote control or AM/FM button on 

the front panel to select your desired radio 

band of FM1, FM2, FM3, AM1, AM2, and the 

selected band will be displayed on the small 

monitor of the front panel.

In RADIO mode:
1.  Press and hold 

 or 

 button on 

the front panel or press and hold  

 / 

 button on the remote control to 

automatically search down/up for an available 

station from the current frequency.

2.  Press 

 or 

 button on the front 

panel or press 

 / 

 button on the 

remote control to manually search up or 

down for your desired station from the 

current frequency.

In RADIO mode:
1.  When pressing and holding the   button 

on the front panel or APS button on the 

remote control, the radio searches from 

the lowest frequency and checks the 

signal strength level until 1 cycle search 

is finished. Then the 6 strongest stations 

are preset to the corresponding preset 

number memory band. The AS operation is 

implemented in each band of the selected 

band. When the AS operation is finished, it 

will resume broadcasting on the M1. It can 

store 3x6 stations for FM and 2x6 stations 

for AM in all.

2.  When briefly pressing   button on the 

front panel or APS button on the remote 

control, the radio searches for each 

preset station from the M1. When the field 

strength level is more than the threshold 

level of the stop level, the radio holds at that 

preset number for a few seconds, and then 

searches again. After finishing a cycle of 

searching, it will stop searching on the M1.
NOTE: 

In FM band, FM1, FM2, FM3 is checked 

once at a time.

In AM band, AM1, AM2 is checked once at 

a time.

In RADIO mode:
1.  To memorize the current frequency on the 

current band, press and hold any one of 

the six preset buttons (1-6).

2.  To recall the preset memory on the 

current band, press one of the preset 

buttons [1-6].

Repeatedly press SEL/EQ button to select ST 

ON or ST OFF mode in FM mode.

1.  In RADIO mode, when the signals of the 

distance radio stations are very weak and 

the receiving effect is bad during tuning, 

repeatedly press SEL/EQ button to select 

LOC OFF mode, then tune again for the 

distant radio station.

2.  In RADIO mode, when the signals from 

the local radio stations are too strong, 

this could lead to interference. Repeatedly 

press SEL/EQ button to select LOC ON 

mode. Re-tune the local station if required.