BEA 10TD900HH4 Benutzerhandbuch
75.5786.01 900 MHz TX-RX 20140723
Page 3 of 4
All Transmitters
Removing Transmitters
Single Transmitter
1
x2
2
1
Press BOTH learn buttons until
red LED flashes once (~2 s).
Press BOTH learn buttons until
blue LED illuminates (~10 s).
Press transmiter TWICE within
10 seconds.
SETUP (cont.)
Push Plate Configuration
2
1
1 2 3
ON
3
Connect transmitter
1
to push plate
(NO & COM) and insert into box.
Follow steps 1-3 in Hand Held
Configuration
Install push plate.
NOTES: 1: 10TD900PB required for push plates
Vestibule Configuration
RECEIVER
TRANSMITTER
LEARN
1
Outer
outer (1)
No Delay
inner (2)
Delay
vestibule (4)
No Delay
Inner
outer (1)
Delay
inner (2)
No Delay
vestibule (3)
No Delay
Battery Replacement
Push Plate (TD900PB)
Handheld (TD900HHx)
1
3 V
2
AAA Battery
AAA Battery
1
Remove back screws and
disassemble.
Replace 2 AAA batteries
observing polarity.
Replace 3 volt (CR2032) battery
observing polarity and reassemble.
Low Battery Indicator - After transmitter button is pressed, low battery is indicated by three (3) transmiter LED blinks.
OUTER
RECEIVER
1
2
3
INNER
RECEIVER
4
Signal Strength Indicator - Pressing and holding transmitter button for 3 seconds activates signal strength tri-color LED
on receiver. Green = strong signal, Yellow = medium signal, Red = weak signal.
For vestibule applications, program each receiver to the appropriate
transmitters according to the chart below and the picture to the right.
NOTE: All transmitters must ONLY be powered with provided batteries or equivalent.