Ingenico RP450BT Benutzerhandbuch
RP457
Mobile Payment Terminal
This
devicesupports magnetic stripe, chip as well as contactless
transactions.
The reader only work with select ROAM supported mobile
devices.
An additional layer of encryption is added to the reader to
guarantee
the card data is protected as it travels from the reader to the
mobile
device. Therefore, the readers cannot be used for any other
merchant
service and must be purchased from ROAM.
ROAM
Data is not liable for any harm caused by the reader to your
mobile
device.
You
agree that neither ROAM nor our vendors, suppliers or licensors are
responsible
for any damages resulting from: (a) anything done or not done
by
someone else; (b) providing or failing to provide Services, including, but
not
limited to, deficiencies or problems with a Device or network coverage
(for
example, dropped, blocked, interrupted calls/messages, etc.); (c)
traffic
or other accidents, or any health‐related claims relating to our
Device
or Services; (d) Data Content or information accessed while using
our
Device or Services; (e) an interruption or failure in accessing or
attempting
to access emergency services from a Device, including through
911,
Enhanced 911 or otherwise; (f) interrupted, failed, or inaccurate
location
information services, (g) information or communication that is
blocked
by a spam filter, or (h) things beyond our control, including acts of
God
(for example, weather‐related phenomena, fire, earthquake,
hurricane,
etc.), riot, strike, war, terrorism or government orders or acts.
©
2007‐2017 ROAM Data, Inc., All Rights Reserved
Usage
(a)
Battery Status
A
Red LED is present next to the USB connector for battery status.
‐Battery charge: DC 5.0V from USB port to charge the battery
‐Battery full: Red LED is on all the time
‐Battery low: Red LED On and Off for 1s every 3s alternatively
‐Battery very low: Red LED On and Off for 1s every 6s alternatively
‐Battery out of capacity: Red LED Off (and Green LED Off)
‐Battery charging: Red LED On and Off every 1sec alternatively
(b)
‐Battery full: Red LED is on all the time
‐Battery low: Red LED On and Off for 1s every 3s alternatively
‐Battery very low: Red LED On and Off for 1s every 6s alternatively
‐Battery out of capacity: Red LED Off (and Green LED Off)
‐Battery charging: Red LED On and Off every 1sec alternatively
(b)
Reader during Swipe/Tap/Dip
There
are 4 LEDs on the top of the reader to indicate progress of a
contactless
transaction. In addition, there is a buzzer inside the reader to
prompt
Swipe/Tap/Dip.
‐Reader ready: The Red LED on the side of the reader will be On.
‐Reader waiting for card: The reader will generate a beep prompting user
to
‐Reader waiting for card: The reader will generate a beep prompting user
to
Swipe/Tap/Dip. One LED lighton top of the reader will turn on (Only for
Contactless).
‐Reader reading the card: 2 LED lightsturn On.
‐Card read successful: 3 LED lightsturn On.
‐Card Processing Error/Multiple Contactless Cards detected: All lights are
turned
‐Card read successful: 3 LED lightsturn On.
‐Card Processing Error/Multiple Contactless Cards detected: All lights are
turned
off to indicate thatthe contactless interface is not acceptablefor this
transaction.
‐Card Processing Error: Only fourth LED light turns On indicating
conditionsfor
conditionsfor
use of the contactless interface havenot been satisfied (ex:
As
an added security measure, transaction amounts over apre‐set
threshold
may require a card swipe or insert.).