Hui Zhou Gaoshengda Technology Co. LTD WT21M2610 Benutzerhandbuch
As long as the three conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed.
Important Note:
In the event that these conditions cannot be met (for example certain laptop configurations or co-
location with another transmitter), then the FCC authorization is no longer considered valid and the FCC
ID cannot be used on the final product. In these circumstances, the OEM integrator will be responsible
for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
location with another transmitter), then the FCC authorization is no longer considered valid and the FCC
ID cannot be used on the final product. In these circumstances, the OEM integrator will be responsible
for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may be maintained between the antenna and users. The final end product must be labeled in
a visible area with the following: Contains FCC ID: 2AC23-WT21M2610.
that 20 cm may be maintained between the antenna and users. The final end product must be labeled in
a visible area with the following: Contains FCC ID: 2AC23-WT21M2610.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or remove this RF module in the user’s manual of the end product which integrates this module.
or remove this RF module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.
Antenna Information
The WT21M2610 has been designed to pass certification with the antenna listed (for BT) below. The
required antenna impedance is 50 ohms.
required antenna impedance is 50 ohms.
The WT21M2610 has been designed to pass certification with ingrate antenna for WLAN.
Model
Type
Connector
Peak gain ( dBi )
Description
2400 – 2483.5 MHz
WC0D-60
PIFA
R-SMA
1.72
BT Antenna