Precision Governors LLC 9557 Benutzerhandbuch
2322 Seventh Avenue --- Rockford, IL 61104 --- 815.229.5300 --- Fax --- 815.229.5342
www.precisiongovernors.com
Page 3 of 5
Once the switch is released, the transmitter will save the new address then blink
the create address indicator. Within 17 seconds, depress each of buttons 1-8 that
are used in the application. The controller will only transmit status of the buttons
learned in this process. After 17 seconds the indicator will stop flashing and the
transmitter will have set the button permissions to those buttons depressed at least
once while the indicator was flashing. Alternatively, while in permission set
mode the create address switch can be depressed to immediately save the
permissions and enter normal usage mode.
are used in the application. The controller will only transmit status of the buttons
learned in this process. After 17 seconds the indicator will stop flashing and the
transmitter will have set the button permissions to those buttons depressed at least
once while the indicator was flashing. Alternatively, while in permission set
mode the create address switch can be depressed to immediately save the
permissions and enter normal usage mode.
Reinstall the battery cover.
Prior to use, the receiver will need to learn the address of the transmitter
following the receiver procedure
Figure 2: Belt Clip and Battery Cover
Figure 3: Create Address Switch and LED
Battery Replacement
Using a small screwdriver or coin, loosen the battery cover on the back of the
remote. Refer to Figure 2 for the location of the battery cover.
Remove both batteries. Replace with two fresh AA batteries.