Wink Labs Inc. WDW1 Benutzerhandbuch
4
Including Sensor (Door Sensor) to Z-wave Network
The door sensor can be included to the Z-wave network by pressing the code button.
1) Disassemble the door sensor main body and insert the battery. Make sure the
device is located within the direct range of the controller.
2) Set the controller into the learning mode (see mail controller’s operating manual).
3) Quickly, triple click the code button, LED light will flash for 5 times.
4) Door sensor will be detected and included in the Z-wave network.
5) Wait for the main controller to configure the sensor.
1) Disassemble the door sensor main body and insert the battery. Make sure the
device is located within the direct range of the controller.
2) Set the controller into the learning mode (see mail controller’s operating manual).
3) Quickly, triple click the code button, LED light will flash for 5 times.
4) Door sensor will be detected and included in the Z-wave network.
5) Wait for the main controller to configure the sensor.
Excluding Sensor (Door Senor) from Z-wave Network
1) Make sure the sensor is connected to power source.
2) Set the main controller into the learning mode (see main controller’s operating
manual).
3) Quickly, triple click the code button, LED light will flash for 5 times.
4) Wait for the main controller to delete the sensor.
2) Set the main controller into the learning mode (see main controller’s operating
manual).
3) Quickly, triple click the code button, LED light will flash for 5 times.
4) Wait for the main controller to delete the sensor.