ATI Industrial Automation 9105WNET Benutzerhandbuch
Wireless F/T Installation and Operation Manual
Document #9620-05-Wireless FT-03
Document #9620-05-Wireless FT-03
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: +1.919.772.0115 • Fax: +1.919.772.8259 • www.ati-ia.com • Email: info@ati-ia.com
58
12. Enter these commands in any order: (Commands are not case sensitive except where indicated)
c.
“MYIP <unitip>”, e.g. “MYIP 192.168.1.50”
d.
“NETMASK <subnetmask>”
e. “GATEIP <defaultgateway>”
f.
“SSID <ssid>” Network<ssid> (Is case sensitive)
g.
“BAND <x>” where x is “2.4” for 2.4 gigahertz or “5” for 5 gigahertz.
h. “DESTIP <yourcomputersip>”
Figure 11.5—Test the Connection
13. Enter the “SAVEALL” command followed by the “RESET” command for the new settings to take effect.
14. Close the terminal program.
15.
14. Close the terminal program.
15.
Press the On/Off switch for two seconds to power down. Then press again to power up. After
initialization the unit will connect to the wireless network and begin streaming data.
16. Disconnect the USB cable from the Wireless F/T unit and the computer.