Tramigo Ltd T-1304 Benutzerhandbuch
13
TRIP
T23 Fleet can be configured to send a report at the start and end of every trip. This is done using
the
T23 Fleet can be configured to send a report at the start and end of every trip. This is done using
the
TRIP
command. A trip is started when the unit has moved more than 300m and faster than 3
km/h. The trip ends after the unit has not moved for 15 minutes (configurable).
The TRIP end will include the following information:
The TRIP end will include the following information:
Start position
End position
Time of trip and idle time
Distance travelled
Average and maximum speed
End position
Time of trip and idle time
Distance travelled
Average and maximum speed
Interim trip reports are available using the NOW parameter. If no trip is in progress you can see
the last trip travelled.
Speed
T23 Fleet can report when it’s exceeded a speed limit you have set. Use the
SPEED
command to
turn on this report.
Zone
T23 Fleet can report when it’s within a specific distance from a location. The
Zone
T23 Fleet can report when it’s within a specific distance from a location. The
ZONE
command can
be used to notify you when your T23 Fleet leaves an area, or is approaching a place.
Ignition Report
For full installations T23 Fleet can be configured to send an Ignition report every time the ignition
is switched on or off. You can turn this report on and off by using the
Ignition Report
For full installations T23 Fleet can be configured to send an Ignition report every time the ignition
is switched on or off. You can turn this report on and off by using the
IGNITION
command.
Navigation Support
T23 Fleet outputs standard NMEA strings to the serial port, to be used with 3
rd
party navigation
systems on PC’s and other devices that run Windows. The availability of navigation varies in each
country. NMEA will be outputted at a Baud rate of 115200.
country. NMEA will be outputted at a Baud rate of 115200.
5.3 Phone Features
Installation Location
Your T23 FLEET unit can be mounted anywhere inside your vehicle or boat where the unit will not
get wet and not exposed to excessive heat. The most common locations are behind the
dashboard, under the centre console, and under a side panel in the back of the vehicle. Pick a
location where you can secure the unit firmly using screws or cable tie.
All phone features require the hands free kit headset (accessory). Voice quality is dependent on the
condition of the GSM network that the user is connected to. For best results call the unit with a
land line.