CREE Inc. RFM Benutzerhandbuch

INSTALLATION INSTRUCTIONS

Cree SmartCast™ Technology Wireless Control Module Replacement Kit

Includes: CR Series and CS Series

LPN00243X0001A0_C

1 of 2

When using electrical equipment, basic safety precautions should always be 

followed including the following:

1.  Before installing turn off the power at the circuit breaker.

2.  Any changes or modifications to these devices not explicitly approved by 

manufacturer could void your authority to operate this equipment.

Cree Logo

Cree Logo

Turn power off and remove old control module 
from luminaire by pressing the clips located on 
both sides of  control module inward and pull 
control module out from luminaire. 
NOTE: For location of the control module 
reference Figure 1 for CR luminaires and 
Figure 2 for CS luminaires.

Orient the new control module so that the 
Cree logo is in the lower left corner. Attach the 
new control module to the CR or CS luminaire 
by pressing in on the clips located on the sides 
of the control module and inserting it into the 
designated connector. 

Turn power on. The new control module is 
correctly installed if the Blue LED displays a 2 
blink sequence. 
NOTE: If the blue LED does not respond 
with the two-blink sequence, please follow 
the RESET instructions to return the control 
module to factory defaults.

On the Configuration Tool, select “Replace 
Devices” from the “Advanced” menu and 
follow the on-screen directions.. This will 
remove old device(s) from the network and 
add the new device(s).

NOTE: The Blue LED is located behind the 
Cree logo on the control module. The Cree 
logo with illuminate blue when the Blue LED is 
active. 

Actuate RESET button through the test hole. 
Push and hold (approximately 10 sec), LED on 
control module will blink fast. 

Release for 1 sec. 

Press/Hold RESET button for 0.5 sec. Light 
will go to full bright and the Blue LED on 
the control module should be in a 2 blink 
sequence.