LED Roadway Lighting Ltd. 0115 Benutzerhandbuch
ASM0115 – Operating Instructions
The ASM0115 module is for use in LED Roadway Lighting Ltd. end product designs only. It is not
intended for resale or use as an independent product. Please refer to the following instructions when
designing with the ASM0115.
1) The attached document “SPZB32W1x1.4.pdf” is an ST Microelectronics datasheet
describing the module including the operating characteristics of the module. The
ASM0115 is identical to the SPZB32W1C1.4. This datasheet should be referenced when
designing the host interface for use with this module.
ASM0115 is identical to the SPZB32W1C1.4. This datasheet should be referenced when
designing the host interface for use with this module.
2) The end device must use the model 47950-0001 antenna from Molex or an antenna of
the same design with equivalent or lower gain.
3) Canada (IC)
You must include Industry Canada Regulatory Information on the end product label as
well as in the product manual.
Label Information
Equipment is subject to certification under the applicable RSS(s), shall be permanently
labelled on each item, or as an inseparable combination.
The label must contain the following information for full compliance:
The Industry Canada certification label of a module shall be clearly visible at all times
when installed in the host device, otherwise the host device must be labelled to display
the Industry Canada certification number of the module, preceded by the words
“Contains transmitter module”, or the word “Contains”, or similar wording expressing the
same meaning, as follows:
“Contains
well as in the product manual.
Label Information
Equipment is subject to certification under the applicable RSS(s), shall be permanently
labelled on each item, or as an inseparable combination.
The label must contain the following information for full compliance:
The Industry Canada certification label of a module shall be clearly visible at all times
when installed in the host device, otherwise the host device must be labelled to display
the Industry Canada certification number of the module, preceded by the words
“Contains transmitter module”, or the word “Contains”, or similar wording expressing the
same meaning, as follows:
“Contains
IC:
12047A-0115”
The applicant for equipment certification of the module shall provide with each unit of the
module either a label such as described above, or an explanation and instructions to the
user as to the host device labelling requirements.
IMPORTANT: This equipment for which a certificate has been issued is not considered
certified if it is not properly labelled. The information on the Canadian label can be
combined with the manufacturer’s other labelling requirements.
Manual Information
The End User Product Manual must contain the following information for full compliance:
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.