NOMi Corporation 3210 Benutzerhandbuch
Brickstream®
3D+ Basic Installation Guide
44
3
|
Installing the Brickstream®
3D+
Smart
Device
On-Site
3
INSTALLING THE BRICKSTREAM®
3D+
SMART
DEVICE ON-SITE
SMART
DEVICE ACCESSORIES
The proper installation and use of the Brickstream®
3D+
Smart
Device requires accessories that
provide a way to mount the Smart
Device and network connectivity using a Power-over-Ethernet
(PoE) switch or PoE injector. The following section provides an overview of the different PoE
devices and mounts that are available for use with the Brickstream®
devices and mounts that are available for use with the Brickstream®
3D+
Smart
Device.
Powering the Brickstream®
3D+ Smart
Device
Industry standard 802.3af PoE connections (with CAT5e Ethernet cable) are supported to
facilitate the combined power and network connection to the Brickstream®
facilitate the combined power and network connection to the Brickstream®
3D+
Smart
Device.
If VPN routers are required, Brickstream recommends using Cisco Small Business RV180 with the
Smart
Smart
Device
implementation.
Power output of the selected PoE switch(es) must minimally support 7
W
typical
power
for
each
connected Smart
Device, but must be rated for up to 12.95
W maximum per Smart
Device.
When selecting from the PoE options, for each Smart
Device you will connect to the PoE, allow
12.95
W in the power budget calculation as described in the PoE’s documentation. The
Brickstream®
3D+
Smart
Device is PoE Class 3, so the PoE must support Class 3 or higher.
Ensure network lights are lit on the Ethernet port of the Brickstream®
3D+
Smart
Device
after
connecting all cables. This ensures the physical connectivity of the network.
All connections use standard CAT5e or higher Ethernet cables. No special cables are necessary.