Ulterius Technologies LLC FDN40 Benutzerhandbuch
CHAPTER 4: RIP
Configuration User Manual
113
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
4.5.14 Configuring Debug Level for RIP
Refer the Section 4.3 for configuration guidelines and Figure 4-1 for the
Setup. The prerequisite configuration needs to be done in the switches
(FDN40-1 and FDN40-2) before configuring RIP.
Setup. The prerequisite configuration needs to be done in the switches
(FDN40-1 and FDN40-2) before configuring RIP.
Execute the following commands in the switch FDN40-1 to configure the
debug level for RIP.
debug level for RIP.
UltOs# config terminal
UltOs(config)# router rip
UltOs(config-router)# network 10.0.0.1
UltOs(config-router)# end
Configure the debug level for RIP module.
UltOs# debug ip rip all
RIP: Sending regular Update over this interface 0
RIP: Authentication not needed for this interface,
So 25 routes can be composed
So 25 routes can be composed
RIP: If Agg Rt added to update with metric : 3
RIP: Sending RIP update through Port 0
RIP: Sending regular Update over this interface 0
RIP: Authentication not needed for this interface,
So 25 routes can be composed
So 25 routes can be composed
RIP: If Agg Rt added to update with metric : 3
RIP: Sending RIP update through Port 0
RIP: Sending regular Update over this interface 0
RIP: Authentication not needed for this interface,
So 25 routes can be composed
So 25 routes can be composed
RIP: If Agg Rt added to update with metric : 3
Disable the debug level for RIP module.
UltOs# no debug ip rip all
4.5.15 Configuring Route Map – RIP
URM (Unified Route Map) is a portable implementation of the route map
capability for IPv4 and IPv6 unicast routing software. The URM provides a
single interface for the administrator to set up and manage route maps. It
also provides a common unified method for routing protocols and static route
management software to use route maps for different purposes. The
independent nature of the implementation helps to avoid the duplication of
the route maps in the different routing modules in a router.
capability for IPv4 and IPv6 unicast routing software. The URM provides a
single interface for the administrator to set up and manage route maps. It
also provides a common unified method for routing protocols and static route
management software to use route maps for different purposes. The
independent nature of the implementation helps to avoid the duplication of
the route maps in the different routing modules in a router.