Ulterius Technologies LLC FDN40 Benutzerhandbuch
CHAPTER 17: RAVPN
`FDN40ConfigUM/20160505
375
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
Policy Name : crypto_map_name
Policy Status : Inactive
Policy Type : IPSec Manual
Ike Version : v1
Local & Remote Protected N/W's : None <-- --> None
Security Mode : Tunnel
Local & Remote Tunnel Term Addr : None <== ==> None
Interface Name : Not Configured
Policy Protocol : any
Policy Action : Apply
In/Out bound SPI : 0 / 0
Security Protocol : ESP
Encryption Algo : Not Configured
Anti Replay : Disable
Crypto Session Status : Inactive
Crypto Session Encr Pkts : 0
Crypto Session Decr Pkts : 0
No.of ACTIVE VPN policies = 0
No.of VPN policies configured = 1
17.3.5 Configuring Peer Identity
Peer identity refers to the destination address set in the packet during
authentication and encryption of outbound datagram. This peer identity is
used for IPSec SA negotiations. This section describes the steps involved in
configuring the peer identity.
authentication and encryption of outbound datagram. This peer identity is
used for IPSec SA negotiations. This section describes the steps involved in
configuring the peer identity.
17.3.5.1 CLI Configuration
To configure the peer identity
-
Enter the Global Configuration mode.
UltOs# configure terminal
-
Enter the Crypto Map Configuration mode for an existing policy.
UltOs(config)# crypto map crypto_map_name
-
Set the peer identity.
UltOs(config-crypto-map)# set peer 35.0.0.2
-
Exit from the Crypto Map Configuration mode.
UltOs(config-crypto-map)# end
To view the VPN policy parameters
-
View the parameters of the VPN policy.