Vubiq Networks Inc. V10G-L Benutzerhandbuch
49
Vubiq HaulPass V10g User Manual
© 2018 Vubiq Networks, Inc. All Rights Reserved
8.2 Special Note for CEService
In general, this is enough for GVRP to work, however the CEService SDK allows the user to configure whether a
L2CP (Layer 2 Control Protocol) is forwarded or sent to the CPU (peered). The default is forwarded.
L2CP (Layer 2 Control Protocol) is forwarded or sent to the CPU (peered). The default is forwarded.
When using CEService, the system must be told how GARP frames should be peered, as follows.
# configure terminal
(config)# interface GigabitEthernet 1/1
(config-if)# gvrp
(config-if)# evc l2cp peer 17
(config-if)# exit
(config)# exit
#
(config)# interface GigabitEthernet 1/1
(config-if)# gvrp
(config-if)# evc l2cp peer 17
(config-if)# exit
(config)# exit
#
In this case 17 is the ID for GARP.
The peering of the GARP protocol can also be configured in the web GUI by going to Configuration > Ethernet
Services > L2CP and then select the port to configure in the upper right corner.
Services > L2CP and then select the port to configure in the upper right corner.
Figure 32. L2CP Peer Forward
The GARP multicast address is 01-80-c2-00-00-21, and is the 17
th
entry in the list above, counting from zero.