IP TRADE SA IPT-WPTT Benutzerhandbuch
WPTT TRANSMITTER USER MANUAL
All rigths reserved to
IP Trade SA
7
1.
Signal transmission status
Transmission LED of the hand-device indicates signal transmission status:
Button
pressed
LED State
Description
Yes
Steady red
Hand-device successfully sends applicative
messages to the WPTT base
Yes
100ms orange/red
blink
Hand-device has failed to send an applicative
message to the WPTT base
No
100ms orange
blink every 3s
No pairing information available, device should be
paired
2.
Charging hand-device
Hand-device is powered through an embedded battery.
The battery has 18 hours autonomy and can be charged within 2 hours.
IP Trade recommends charging the hand-device battery using provided USB cable.
Note: when charging the clip on “hand-device” on a turret with the “USB” base
connected, the 2 units will pair.
Power LED of the hand-device indicates battery charge status:
USB
connected
LED State
Description
No
100ms green blink every 3s
The battery has a good level
No
100ms orange blink every 3s
The battery level is down, it should be
recharged
Yes
500ms green blink every 1s
The battery is charging
Yes
Steady green
The battery is fully charged
IV.
Limitations
• 2 free USB ports on the device (turret) are needed
• Only use IP Trade WPTT certified USB cable when connecting WPTT Hand-
• Only use IP Trade WPTT certified USB cable when connecting WPTT Hand-
Device
• Hand-device cannot be used while connected to USB
• Hand-device isn't operational right after having unplugged from USB, user
• Hand-device isn't operational right after having unplugged from USB, user
must wait 5 seconds before using it.