ANGEL TECHNOLOGY CO. LTD. L706 Benutzerhandbuch

Any Changes or modifications not expressly approved by the party responsible for compliance could void 

the user's authority to operate the equipment.   

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 

This device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or television reception, 

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:     

—Reorient or relocate the receiving antenna.     

—Increase the separation between the equipment and receiver.     

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.     

—Consult the dealer or an experienced radio/TV technician for help. 

SAR tests are conducted using standard operating positions accepted by the FCC with the phone 

transmitting at its highest certified power level in all tested frequency bands, although the SAR is 

determined at the highest certified power level, the actual SAR level of the phone while operating can be 

well below the maximum value, in general, the closer you are to a wireless base station antenna, the lower 

the power output. Before a new model phone is a available for sale to the public, it must be tested and 

certified to the FCC that it does not exceed the exposure limit established by the FCC, Tests for each 

phone are performed in positions and locations (e.g. at the ear and worn on the body)as required by the 

FCC. For body worn operation, this tablet P  C has been tested and meets the FCC RF exposure 

guidelines when used with an accessory designated for this product or when used with an accessory that 

contains no metal and that positions the handset a minimum of  0    cm from the body. Non-compliance 

with the above restrictions may result in violation of RF exposure guidelines.