SHENZHEN AVWOO TECHNOLOGY CO. LTD A021 Benutzerhandbuch

SIZE: 70x158mm

FCC NOTICE:

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interfer-

ence to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more

of the following measures:
● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and

receiver.

● Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

● Consult the dealer or an experienced radio/TV

technician for help.

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received,

including interference that may cause undesired

operation.

2. Changes or modifications not expressly approved by the

party responsible for compliance could void the user's

authority to operate the equipment.
FCC WARNING:

To assure continued operation, follow the attached

installation instructions and use only shield cables when

connecting to other devices. Changes or modifications not

expressly approved by the party responsible for

compliance could void the user's authority to operate the

equipment.

POSSIBLE SOLUTION
Recharge the built-in battery as

page 2.
Increase the volume by press

and hold the Button
Rise the volume level of the

paired/connected device

Reduce the volume level by

press and hold the Button
Reduce the volume level of the

connected/paired device

Pair the external BT Device to

the unit as page 3.
Place the external BT device

close to the unit

POSSIBLE CAUSE
Built-in battery drained

Volume of the unit was set

to minimum position
Volume level of

paired/connected device

is in low level
Volume level too high

Volume level of the

connected/paired device

too high
The external BT Device

had NOT paired to the unit
The external BT device

too far from the unit

SYMPTOM
Can’t power on

No sound or

sound weak

Sound

distortion

BT not

functioning

C. Do not over charge longer than 24 hours. Excessive

charging or running the unit until battery fully drains will

damage battery. Battery life will be extended if you keep

the battery fully charged.

D. Battery life naturally shortens slowly over time.

E. The rechargeable battery incorporated in this product is

not user replaceable.

OPERATION:

General Operation:
1. Recharge the built-in Li-ion battery as previously instructed.

2. Press and hold the

Button approximately 3 seconds to

power on the unit. The Blue Indicator on the front of unit

will illuminate.

3. Press and release the Button repeatedly to switch to

desired playback mode. The unit will sound the prompt

with your selection (see list below):

Note: If the Micro SD Card is NOT inserted into the SD

Card Slot and/or the External Audio Player is NOT

connecting to the AUX (in) Jack, the selection of Micro

SD Card/AUX IN (LINE IN) will not available.

4. During playback, press and hold the or Buttons to

adjust volume level as desired.

5. Press the Button repeatedly to turn On/Off and/or set

the blinking modes of the Decorative LED Lights.

6. When finished listening, press and hold the Button to

shut off the unit.

BT Mode:
BT (Bluetooth) pairing:

First time use or re-pairing the unit to a new BT Device, pair

as follows:

1. Power on the unit and enter to BT mode as previously

instructed. The Blue Indicator on the front of unit will

illuminate and blink. The unit also will sound a prompt

“Bluetooth ready for connection”.

2. Power on the external BT Device and enter to BT

searching mode. Start pairing following the on screen

instructions from the external BT Device. When paired，

the unit will sound a prompt “Bluetooth connected” and

the Blue Indicator will stop blinking.

3. If pairing is complete you may now play music and

answer calls with your external BT Device.

4. During playback:

● Press the Button on the unit to pause, press again

to resume normal playback.

● Press and hold the or Buttons to adjust volume

level as desired.

● Press and release the or Buttons repeatedly to

skip tracks.

5. If the unit is paired to a Cell Phone and a call is incoming

during an active music session, press the Button to

pause the music playback then speak to the built-in

microphone to answer the call. When your call is complete,

press the Button to end the call and resume to music

playback.

6. When finished listening, press and hold the Button to

shut off the unit.

Notes:

● When the external BT Device searched the unit, our model

number “MMA3623” will appear on the display of external

BT Device.

● If while pairing you are asked for a code please try "0000"

or "1234".
Normal operation after pairing:

1. Power on the external BT Device and enter to BT

playback mode.

2. Power on the unit and enter to BT mode as previously

instructed. The Blue Indicator on the front of unit will

illuminate and blink. The unit also will sound a prompt

“Bluetooth ready for connection”.

3. Wait a few seconds until the unit is automatically paired to

the external BT Device. The unit will sound a prompt

“Bluetooth connected” and the Blue Indicator will stop blinking.

4. After pairing is complete you may now play music and

answer calls with your external BT Device.
AUX (in):
To listen from the external Music Player such as a MP3

Player, Discman…etc.

1. Open the Rubber Cover on the unit.

2. Connect one end of the supplied Audio Connection Cable

to the AUX Out/Line Out/Phone Jack on the external

Audio Player.

3. In power on mode, connect the other end of the cable to

the AUX (in) Jack as illustrated follows. The unit will turn

to AUX (in) mode automatically and will sound a prompt

"Line in".

Note: If the unit is not in AUX In (Line in) mode or you

want to switch to other playback modes, press and release

the Button to switch to desired playback mode.

To AUX Out/Line Out/

Phone Jack on the

external Audio Player

4. Play the music on the connected Player as usual. (Make

sure the volume level of the connected Audio Player is

turned to high level.)

5. During playback:

● Press and hold the or Button to adjust volume

level as desired.

● Press the Button to mute the sound, press again to

turn the sound back.

6. When finished listening, press and hold the Button to

shut off the unit.

TF (Micro SD):
To play the music in Micro SD Card:

1. Open the Rubber Cover on the unit.

2. In power off mode, insert the Micro SD Card (not included)

into the Micro SD Card Slot on the unit with contacts

facing up as illustrated below:

3. Power on the unit and enter to Micro SD Card mode as

previously instructed. The unit also will sound a prompt

“Memory Card" then automatically play the music stored

on the card.

4. During playback:

● Press the Button to pause, press again to resume

normal playback.

● Press and hold the or Buttons to adjust volume

level as desired.

● Press and release the or Buttons repeatedly to

skip tracks.

5. When finished listening, press and hold the Button to

turn off the unit.
Notes:

● Up to 16 GB Micro SD Card the unit supports to play.

● Before replacing Micro SD Card, make sure the unit has

been powered off.

● When inserting the Micro SD Card, make sure the

direction you selected is correct. Never insert violently to

avoid damaging the Micro SD Card or the unit.

● If it doesn’t work, please check if the direction is correct.

● You also need to download the desired music in MP3

format into the Micro SD Card before insert into the unit.

TROUBLESHOOTING:

Check the following before requesting service:

SPECIFICATIONS:

PACKAGE INCLUDES:

1 x Owner's Manual

1 x USB Connection Cable (For charge only)

1 x Audio Connection Cables with 3.5mm Plugs

SPECIFICATIONS AND ACCESSORIES ARE SUBJECT

TO CHANGE WITHOUT NOTICE.

LOCATION OF CONTROLS:

1. (Decorative LED Lights On/Off and

Blinking Modes Selection) Button

(Power On/Off and Mode Selection) Button

Button

Micro USB Port (For Charge only)

Micro SD Card Slot

8. AUX (in) Jack

9. Rubber Cover (This cover is for

water and dusts Ingress

Protection; always make sure it

is completely closed)

10. Metallic Buckle

11. Built-in Microphone

12. Decorative LED Lights

13. Indicators

POWER SOURCE:

The unit has a built-in Li-ion rechargeable battery, recharge

it before use or when it is drained as follows:

1. Open the Rubber Cover on the unit.

2. Connect the Micro USB Plug from the supplied USB

Connection Cable to the Micro USB Port.

3. Connect the full sized USB Plug from the supplied USB

Connection Cable to the USB Port on Computer or USB

Charger (Not included). Charging will automatically start.

● During charging, the Red Charging Indicator on the front

of unit will illuminate. When finished, it will turn off.

● During charging, you can also listen to music at the

same time.

To Computer or any

USB Charger

NOTES:

The Rubber cover is for water and dusts Ingress

Protection; always make sure it is completely closed.

IMPORTANT:

Your battery will last longer if you follow these simple guidelines

for caring and storing.

A. Before first time use, charge it approximate 3 hours until

the unit is fully charged.

B. Recharging and store the unit within the temperature range

of 5°C~35°C (40°F~95°F).

Power Source

Dusts/Water Ingress

Protection Level
Impedance of Speakers
Audio Power
BT Version
BT Operation Distance

Built-in DC 3.7V, 1000 mAH (3.7WH) rechargeable Li-ion

battery; Recharge by DC 5V through Micro USB Port
IP67

5W; 3 ohm

1.5W (RMS）
4.1
≧

32 Feet in open area

Voice Prompt:
Bluetooth ready for connection
Memory Card
Line in

Playback Mode:
BT (Bluetooth)
Micro SD Card
AUX IN (LINE IN)

Craig Electronics warrants this product to be free from

manufacturing defects in material and workmanship

under normal use for a period of 180 days from date of

purchase. If service is required, please return the product

to the store where it was purchased for exchange; or,

pack the unit in the original packing material with all

accessories if applicable, a copy of your sales receipt and

a Cashier’s check or Money Order for $7 (to cover

shipping and handling costs) payable to Craig Electronics

Inc. For consumers in Canada, please make sure that the

cashier check or money order is redeemable through a

U.S. bank. Ship your product freight pre-paid. Your unit

will be repaired, replaced or if the unit cannot be repaired

or replaced, a refund will be forwarded to you within four

weeks of receipt of your unit. Please ship your unit to:

Craig Electronics Inc.

1160 NW 163 Drive

Miami, Fl 33169

This warranty is void if the product has been: a) Used in a

commercial application or rental. b) Damaged through

misuse, negligence, or abuse. c) Modified or repaired by

anyone other than an authorized Craig service center. d)

Damaged because it is improperly connected to any other

equipment.

Note: This warranty does not cover: a) Ordinary adjustments

as outlined in the Owner’s Manual which can be performed

by the customer. b) Damage to equipment not properly

connected to the product. c) Any cost incurred in shipping

the product for repair. d) Damage to the product not used

in the USA.
This warranty is not transferable and only applies to the

original purchase. Any implied warranties, including the

warranty of merchantability, are limited in duration to the

period of this expressed warranty and no warranty

whether expressed or implied shall apply to the product

thereafter.
Under no circumstance shall Craig be liable for any loss or

consequential damage arising out of the use of this product.

This warranty gives specific legal rights. However, you

may have other rights which may vary from state to state.

Some states do not allow limitations on implied warranties

or exclusion of consequential damage. Therefore, these

restrictions may not apply to you.
This product has been manufactured by and is sold under

the responsibility of Craig Electronics Inc, and Craig

Electronics Inc is the warrantor in relation to this product.

MAGNAVOX and SMART. VERY SMART are registered

trademarks of Koninklijke Philips N.V. and are used under

license from Koninklijke Philips N.V.

To Obtain Service on your Product

email:service@craigelectronics.com

Printed in China

MMA3623_WC_E0FK1_B0US

LIMITED WARRANTY

To AUX (in) Jack

To Micro USB Port

Portable waterproof speaker

MMA3623, A021, A022