SHENZHEN AVWOO TECHNOLOGY CO. LTD A023 Benutzerhandbuch

This equipment has been tested and found to comply with 

the limits for a Class B digital device, pursuant to Part 15 of 

the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and 

can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interfer-

ence to radio or television reception, which can be 

determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more 

of the following measures:
 ● Reorient or relocate the receiving antenna.  

 ● Increase the separation between the equipment and 

     receiver.   

 ● Connect the equipment into an outlet on a circuit 

     different from that to which the receiver is connected.  

 ● Consult the dealer or an experienced radio/TV 

     technician for help.

To assure continued operation, follow the attached 

installation instructions and use only shield cables when 

connecting to other devices. Changes or modifications not 

expressly approved by the party responsible for 

compliance could void the user's authority to operate the 

equipment. 

                                                               

1

 

POSSIBLE SOLUTION
Recharge the built-in battery as 

page 2.
Increase the volume by press 

and holding the      Button
Rise the volume level of the 

paired/connected device

Reduce the volume level by 

press and holding the      Button
Reduce the volume level of the 

connected/paired device

Pair the external BT Device to 

the unit as page 2.
Place the external BT device 

close to the unit

POSSIBLE CAUSE
Built in battery drained

Volume of the unit was set 

to minimum position
Volume level of 

paired/connected device 

is in low level
Volume level too high

Volume level of the 

connected/paired device 

too high
The external BT Device 

had NOT paired to the unit
The external BT device 

too far from the unit

SYMPTOM
Can’t power on

No sound or 

sound weak

Sound 

distortion

BT not 

functioning

C. Do not charge longer than 24 hours. Excessive charging 

     or running the unit until battery fully drains will damage 

     battery. Battery life will be extended if you keep the 

     battery fully charged.

D. Battery life naturally shortens slowly over time.

E. The rechargeable battery incorporated in this product is 

     not user replaceable.

First time use or re-pairing the unit to a new BT Device, pair 

as follows:

1. Power on the unit by pressing and holding the 

M Button 

    on the top of the unit approximately 1 second until the  

    White Indicator on the top of unit is illuminate and blink. 

    The unit will enter to BT (Bluetooth) mode automatically. 

    (If Micro SD Card and/ or Audio Connection Cable was 

    inserted into the unit. Unplug them from unit before power 

    on or press the 

M Button repeatedly to switch to BT mode.)

2. Power on the external BT Device and enter to BT 

    searching mode. Start pairing following the on screen 

    instructions from the external BT Device. After paired, 

    the unit will sound a prompt tone and the White Indicator 

    will stop blinking.

3. If pairing is complete you may now play music and answer 

    calls with your external BT Device.

4. During playback:

    ● Press the ► Button on the unit to pause, press again 

       to resume normalplayback. 

    ● Press and holding the      or      Buttons to adjust volume 

       level as desired.

    ● Press and release the      or      Buttons repeatedly to 

       skip tracks.

    ● Press the 

M Button repeatedly to switch to other 

       playback mode.

5. If the unit is paired to a Cell Phone and a call is incoming 

    during an active music session, press the ► Button to 

    pause the music playback. Then speak to the built- in 

    microphone to answer the call. When your call is complete, 

    press the ► Button to disconnect or end the call and 

    resume to music playback.

6. When finished listening, press and hold the 

M Button to 

    shut off the unit.

3

MODEL: MMA3639

PLEASE READ BEFORE OPERATING THIS EQUIPMENT.

®

Craig Electronics warrants this product to be free from 

manufacturing defects in material and workmanship 

under normal use for a period of 180 days from date of 

purchase. If service is required, please return the product 

to the store where it was purchased for exchange; or, 

pack the unit in the original packing material with all 

accessories if applicable, a copy of your sales receipt and 

a Cashier’s check or Money Order for $12 (to cover 

shipping and handling costs) payable to Craig Electronics 

Inc. For consumers in Canada, please make sure that the 

cashier check or money order is redeemable through a 

U.S. bank. Ship your product freight pre-paid. Your unit 

will be repaired, replaced or if the unit cannot be repaired 

or replaced, a refund will be forwarded to you within four 

weeks of receipt of your unit. Please ship your unit to:

Craig Electronics Inc.

1160 NW 163 Drive

Miami, Fl 33169

This warranty is void if the product has been: a) Used in a 

commercial application or rental. b) Damaged through 

misuse, negligence, or abuse. c) Modified or repaired by 

anyone other than an authorized Craig service center. d) 

Damaged because it is improperly connected to any other 

equipment.

Note: This warranty does not cover: a) Ordinary 

adjustments as outlined in the Owner’s Manual which can 

be performed by the customer. b) Damage to equipment 

not properly connected to the product. c) Any cost 

incurred in shipping the product for repair. d) Damage to 

the product not used in the USA.
This warranty is not transferable and only applies to the 

original purchase. Any implied warranties, including the 

warranty of merchantability, are limited in duration to the 

period of this expressed warranty and no warranty 

whether expressed or implied shall apply to the product 

thereafter.
Under no circumstance shall Craig be liable for any loss or 

consequential damage arising out of the use of this 

product. This warranty gives specific legal rights. 

However, you may have other rights which may vary from 

state to state. Some states do not allow limitations on 

implied warranties or exclusion of consequential damage. 

Therefore, these restrictions may not apply to you.
This product has been manufactured by and is sold under 

the responsibility of Craig Electronics Inc, and Craig 

Electronics Inc  is the warrantor in relation to this product. 

MAGNAVOX and SMART. VERY SMART are registered 

trademarks of Koninklijke Philips N.V. and are used under 

license from Koninklijke Philips N.V.

To Obtain Service on your Product

email:service@craigelectronics.com

Printed in China 

MMA3639_WC_E0FK1_B0WU

● When the external BT Device searched the unit, our model 

   number “MMA3639” will appear on the display of external 

   BT Device.

● If while pairing you are asked for a code please try "0000" 

   or "1234".

1. Power on the unit by pressing and holding the 

M Button 

    on the top of the unit approximately 1 second until the 

    White Indicator on the front of unit is illuminate and blink. 

    The unit will enter to BT (Bluetooth) mode automatically. 

    (If Micro SD Card and/or Audio Connection Cable was 

    inserted into the unit, press the 

M Button repeatedly to 

    switch to BT mode.)

2. Wait a few seconds until the unit is automatically paired 

    to the external BT Device

3. After pairing is complete, the unit will sound a prompt 

    tone and the White Indicator will stop blinking. You may 

    now play music and answer calls with your external BT 

    Device.

To listen from an external Audio Player such as a MP3 Player, 

Discman …etc.

1. Open the Rubber Cover on the rear of unit.

2. Connect one end of the supplied Audio Connection Cable 

    to the AUX Out/Line Out/Phone Jack on the external 

    Audio Player.

3. In power on mode, connect the other end of the cable to 

    the LINE IN Jack as the illustrated below. The unit will 

    turn to LINE IN mode automatically. 

         To AUX Out/Line Out/

          Phone Jack on the 

          external Audio Player

        

4. Play the music on the connected Player as usual. (Make 

    sure the volume level of the connected Audio Player is 

    turned to high level.)

5. During playback:

    ● Press the ► Button to mute the sound, press again to 

       turn the sound back. 

    ● Press and holding the     or     Buttons to adjust volume 

       level as desired.

    ● Press the 

M Button repeatedly to switch to other 

       playback mode. 

6. When finished listening, press and hold the 

M Button to 

    shut off the unit.

4

1. Open the Rubber Cover on the rear of unit.

2. Insert the Micro SD Card into the Micro SD Card Slot 

    with contact finger face to up as the illustrated follows:

3. Power on the unit by pressing and holding the 

M Button 

    on the top of the unit approximately 1 second. The unit 

    will plays the song/music on the Micro SD Card 

    automatically.

4. During playback:

    ● Press the ► Button to mute the sound, press again to 

       turn the sound back. 

    ● Press and holding the      or      Buttons to adjust 

       volume level as desired.

    ● Press and release the      or      Buttons repeatedly to 

       skip tracks.

    ● Press the 

M Button repeatedly to switch to other 

       playback mode. 

5. When finished listening, press and hold the 

M Button to 

    shut off the unit.

● Up to 16 GB Micro SD Card the unit support to play.

● Before replacing Micro SD Card, make sure the unit has 

   been powered off.

● When inserting the Micro SD Card, make sure the 

   direction you selected is correct. Never insert violently to 

   avoid damaging the Micro SD Card or the unit.

● If it doesn’t work, please check if the direction is correct.

● You also need to download the desired music in MP3 

   format into the Micro SD Card before insert into the unit.

5

Check the following before requesting service:

1 x User's Manual

1 x USB Connection Cable (For charge only)

1 x Audio Connection Cables with 3.5mm Plugs 

6

                                       1. M Button                                                                                                                                                                                    

                                       2.     Button                                                                                                                                                                                                                   

                                       3. ►Button 

                                       4.     Button 

                                       5. White Indictor

                                       6. Rubber Cover (This cover is for

                                           water and dusts Ingress

                                           Protection; always make sure it 

                                           is completely closed)  

                                       7. LINE IN Jack

                                       8. Micro USB Port (For charge only)

                                       9. Micro SD Card Slot

                                     10. Red Charging Indictor

                                     11. Reset Button (Inside the hole)

                                     12. Built-in Microphone                                                                                                                                                                                                                                                                                                                

                                     13. Metallic Buckle

The unit has a built in Li-ion rechargeable battery, recharge it 

before use or when the battery is drained as follows:

1. Open the Rubber Cover on the rear of unit.

2. Connect the Micro USB Plug from the supplied USB 

    Connection Cable to the Micro USB Port.

3. Connect the full sized USB Plug from the supplied USB 

    Connection Cable to the USB Port on Computer or USB 

    Charger (Not included).Charging will automatically start. 

    ● During charging, the Red Charging Indicator on the rear 

       of unit will illuminate. When finished, it will turn off. 

    ● During charging, you can also play and listen music at 

       the same time.

                                                 To Computer or any USB Charger  

                              

Your battery will last longer if you're following these simple 

guidelines for charging and storing.

A. Before first time use, charge it approximately 4 hours until 

    the unit is fully charged.

B. Recharge and store the unit within the temperature range 

    of 5°C~35°(40°F~95°F).

2

Power Source

Dusts/Water Ingress 

Protection Level 
Impedance of Speakers
Audio Power
BT Version
BT Operation Distance                                   

Built-in DC        3.7V, 1000 mAH(3.7WH) rechargeable Li-ion 

battery; Recharge by DC         5V through Micro USB Port
IP67

2 x 5 W; 3 ohm

3W per Channel (Total 6 W, RMS）
4.1
≧

 32 Feet in open area 

Portable waterproof Speaker

MMA3639, A023