PAWBO INC. PPCPW01 Benutzerhandbuch
3
Re-pairing and Changing
Network Settings
重新配對與更換網路設定
重新配對與更換網路設定
當手機與產品無法配對,或更換網路設
定時,請重新配對。將卡針插到電源鈕旁
邊的重置孔約3秒,看到水位窗的藍燈閃
爍,開始進入配對狀態,再按照App上的
步驟完成配對。
If you are unable to pair your phone
with the product, or if the network
settings have been changed, please
re-pair. Insert a pin into the reset
button next to the power button for
around 3 seconds, until the status
indicator light is flashing blue. The
product will enter pairing mode.
Complete pairing by following the
steps on the app.
3
Launch the Pawbo Spring app and
proceed with setup
A. When the status indicator light is
flashing blue, it means the product is
pairing.
B. Launch the Pawbo Spring app and
select "Pawbo Spring", then follow
the provided steps to complete
pairing. Upon successful pairing, the
light will flash slowly in blue. Fill the
water tank with the recommended
amount of water and place back
inside the main unit.
* The light flash slowly in red when
the water level is low (no water).
開啟Pawbo Spring App來進行設定
A. 當水位窗燈號變成藍燈閃爍表示產品
進入配對狀態。
B. 打開“Pawbo Spring”App選取
“Pawbo Spring”
,跟著步驟進行配對,
配對成功後會變成藍燈呼吸狀態,再將
水箱加入建議水量放回本機內。
* 低(無)水量時為紅燈呼吸狀態。