Wallys Communications Technologies Co. Ltd DR344-NAS27 Benutzerhandbuch

Seite von 4
http://www.wallystech.com/
4
Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation.
· If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
The device operates in 5.18 ~ 5.24GHz / 5.745 ~ 5.825 GHz frequency range. It is
restricted in indoor environment only. This device meets all the other requirements
specified in Part 15E, Section 15.407 of the FCC Rules.
RF exposure warning:
The device complies with the requirements of FCC/CE RF Exposure.
.
NOTE: Any changes or modifications not expressly approved by the grantee of
this device could void the user's authority to operate the equipment.
The device complies with RF specifications when the device used at least 
22 cm from your body.
The device use the MMCX to connect with the antenna.