Valeport Ltd 0804IDU Benutzerhandbuch
HydrINS 2 / HydrINS 2 Mini flow meter
Installation Manual
Page 10 / 83
The flow value is obtained via the following processing chain:
Figure 2: HydrINS 2/HydrINS 2 Mini data processing system
2.2 Environmental and safety conditions
Optimum use of the HydrINS 2 flow meter requires a suitable measurement environment in order to
avoid as far as possible any environmental disturbances that could affect the measurement.
avoid as far as possible any environmental disturbances that could affect the measurement.
Hydreka shall not be held liable for the quality of the measurements performed using the HydrINS 2 /
HydrINS 2 Mini flow meter if the recommendations given below are not observed.
HydrINS 2 Mini flow meter if the recommendations given below are not observed.
2.3 Conditions in the measurement environment
Protection: IP 68 (NEMA 6):
HydrINS 2: 72 hours under 10 metres (32.8 feet)
Display units: 72 hours under 2 metres (6.56 feet)
Display units: 72 hours under 2 metres (6.56 feet)
Operating temperature range: -20°C (-4°F) to +60°C (140°F)
Storage temperature range: -20°C (-4°F) to +70°C (158°F)
Measured velocity Vm
Q = A × Fi × Fp × Vm
Where:
Q: flow rate
A: internal cross-section (calculated by Winfluid software from the inside diameter,
DI)
DI)
Fi: insertion factor (calculated by the Winfluid software)
Fp: profile factor (calculated by the Winfluid software)
Vm: measured velocity