Shenzhen AEE Aviation Technology Co. Ltd AEEAP120001 Benutzerhandbuch

Remote control and Wi-Fi Repeater Description

Remote control 

(U.S. Mode)

UP

UP

 LEFT

 LEFT

 FORWARD

 FORWARD

LEFT

TURN

LEFT

TURN

TURN
RIGHT

TURN
RIGHT

RIGHT

RIGHT

BACK

BACK

DOWN

DOWN

Quadcopter Direction

("        " indicates nose direction)

10

Taking off and Landing(Outdoors) 

Taking off:

Landing

：

1) Place Quadcopter (with full power battery) on a flat and open ground, and ensure Tail Indicator faces toward you.
2) Power on the Remote control,Wi-Fi Repeater and Quadcopter in sequence.
3) Be sure the Remote control is set exactly as the figure below.

4) Starting motors: toggle the left joystick to left bottom corner and toggle right joystick to right bottom corner at the mean time to start motors.
5) Push the left joystick slowly, then Quadcopter take off. Please refer AEE Quadcopter User Manual  for more details.

Note:

The motors can not be started until GPS signal is ready(Tail Indicator(green) remains on) , when the S4 is in GPS mode.

1) Slowly pull the left joystick to lower Quadcopter until it touches the ground(only on

 a

 flat and open ground).

2) After landing, pull the left joystick to the lowest position and hold for more than 3 seconds until the motors stop.
3) Power off Quadcopter by sliding the switch to OFF.
4) Remove the battery.
5) Power off Remote control and Wi-Fi Repeater.

Important:

1) Control the flight height under your control during your first flight.
2)

Do not toggle the left joystick to left bottom corner and toggle right joystick to right bottom corner during flight ,or it will cause the motors to stop working and

    the Quadcopter will drop without control.

[ 1 ] Propeller                  [ 2 ] Motor                       [ 3 ] Front Indicator                        [ 4 ] Camera

[ 5 ] Landing Gear

[ 6 ]

Mini USB Port

[ 7 ] Micro SD Card Slot                 [ 8 ] 

3-Axial Gimbal

[ 9 ] Quadcopter Battery  [ 10 ] Tail Indicator         [ 11 ] Power Switch                        [ 12 ] Rear Indicator      

[ 13 ] Battery Level LCD Segment Display            [ 14 ] Battery Level Check Button  [ 15 ] 

4XJUDI

Note

: The Remote Control is set to U.S. mode by default.

Power Switch

Charging Port 
(mini USB port) 
Pairing Button 

Repeater Base

Power Indicator

Wi-Fi Indicator

Lock Screw 

Disclaimer

Please read this disclaimer carefully before using the product of Quadcopter. This product is not suitable for people under the age of 18. By using this 
product, you hereby agree to this disclaimer and signify that you have read them fully. You agree that you are responsible for your own conduct and 
content while using this product, and for any consequences there of. You agree to use this product only for purposes that are proper and in accordance 
with the terms and any applicable or guidelines AEE may make available. 
1.

Shenzhen AEE Aviation Technology Co.,Ltd.

 reserves the right of final interpretation of this disclaimer. 

2. Any part of this disclaimer is subject to change without prior notice.
5IJTEJTDMBJNFSJTBWBJMBCMFJONVMUJQMFMBOHVBHFT*ODBTFPGBOZEJTDSFQBODZ UIF$IJOFTFWFSTJPOTIBMMQSFWBJM
'PSNPSFEFUBJMFEPSMBUFTUQSPEVDUJOGPSNBUJPO QMFBTFWJTJU6TFS.BOVBMBOEXXXBFFDPN

Battery
Compartment

S3:

Middle

S1:

S2:

S4:

Antenna

Wi-Fi Repeater

Repeater Base

Gimbal Control Switch S3 

Photo Shooting & 
Video Recording Indicator 

Strap Hole 

Right Joystick 

Video Stop Button

Remote Control 
Power Switch

Smartphone Holder

Remote Control 
Power Indicator

 Status Indicator

Left Joystick

Airborne

Shutter Button

Airborne Video 

Recording Button

Hook Open/Close Button

Hook Open/

Close Button

Buzzer Hole

Return Button

Return Button

Calibration Switch S2

Speed Switch S1

Flight Mode Switch S4