Henis Electronic Technology Co. Ltd JY6100 Benutzerhandbuch
Installation Instructions:
1.
Replace the existing door viewer or drill a 14mm hole in the door at
the required height. Peel off the 3M sticker from the back side of the
camera, insert the camera from outside of the door, make sure the call
button is at the bottom and adjust it to make the camera vertical
camera, insert the camera from outside of the door, make sure the call
button is at the bottom and adjust it to make the camera vertical
(Fig.1).
2.
Peel off the 3M sticker from the holding plate and fit it over the end of
the lens, then screw the locking barrel on to the threaded sleeve of the
camera and tighten it. This will hold the plate to the door. Make sure
that the arrow on the plate points upwards
camera and tighten it. This will hold the plate to the door. Make sure
that the arrow on the plate points upwards
(Fig.2).
3. The data cable should be fully plugged in at the back of the screen. The
excess cable should be gently placed into the groove at the back of the
screen.
excess cable should be gently placed into the groove at the back of the
screen.
4. Hook the screen over the bracket at the top of the plate and secure with one
small screw through the hole at the side of screen case (Fig.3).
small screw through the hole at the side of screen case (Fig.3).
DOOR
Fig. 1
Fig. 2
Fig. 4
hook the screen case
fix the
screw
screw
Fig. 3