Hitachi VANCOUVER 40GB 2YR WARR IC35L060AVV207 Benutzerhandbuch
Produktcode
IC35L060AVV207
6.3.4.4 Power Up In Standby
The figure below shows the jumper positions used to select Device 0, Device 1, Cable Selection, or
Device 1 (Slave) Present to enable Power Up In Standby.
Device 1 (Slave) Present to enable Power Up In Standby.
G
I
E
C
A
H
F
D
B
DEVICE 0 (Master)
G
I
E
C
A
H
F
D
B
DEVICE 1 (Slave)
G
I
E
C
A
H
F
D
B
CABLE SEL
G
I
E
C
A
H
F
D
B
DEVICE 1 (Slave) Present
Figure 50. Jumper settings for Disabling Auto Spin
Notes:
1.
These jumper settings are used for limiting power supply current when multiple drives are used.
2.
Command to spin up is SET FEATURES (subcommand 07h). Refer to 12.28 Set Features.
3.
To enable the CSEL mode (Cable Selection mode) the jumper block must be installed at E-F. In
CSEL mode, the drive address is determined by AT interface signal #28 as follows:
CSEL mode, the drive address is determined by AT interface signal #28 as follows:
y
When CSEL is grounded or at a low level, the drive address is 0 (Device 0).
y
When CSEL is open or at a high level, the drive address is 1 (Device 1).
Deskstar 180GXP hard disk drive specifications
44