embedded wireless GmbH MORIN01 Benutzerhandbuch

MORIN Module. B2B-Module.

2

Documentation

Setup Hardware

Setup via Web-Interface:

Connect your Morin-Board with a standard USB TypeA/B Cable to a standard USB power supply or your PC
USB-port.

Use Ethernet switch jacks to connect your PC/Switch to the Morin Board.

Morin static IP-Address: 192.168.1.1 Mask: 255.255.255.0

Use Web Browser or telnet to connect.

Note: Use ssh instead when Morin Evaluation-Board admin password is configured. Telnet is switched to ssh
by password configuration.

Optional: Setup via Serial-USB-Interface:

Connect the Morin Board with a standard USB TypeA/B Cable to the USB-port of your PC. Based on your
specific operating system you are able to open a serial connection with a terminal application of your choice.

Configure serial settings: 115200-8-N-1

Note: If needed install driver:

USB COM DRIVER:

Rescue Mode:

If you need to reset to the originally generated firmware, because Morin-Board doesn’t boot anymore, rescue
mode is the way to load Firmware via WEB Browser:

Power cycle the Morin-Board while Jumpstart button is pressed. Release Jumpstart button after 1s.

Put a firmware file via WEB Browser to the Morin Evaluation-Board. http://192.168.1.1/index.html Mask:
255.255.255.

1.)  http://192.168.1.1/index.html. Maybe you have to use „priivate surf“. Depends an your browser

vendor.