Non Typical Inc. 17R1-0915M-01 Benutzerhandbuch

Seite von 24
CuddeLink Manual 
 
Version 2.20.2017 
Page 1 of 24

CuddeLink 
 
FCC Notice 
Changes or modifications not expressly approved by the party responsible for compliance could 
void the user’s authority to operate the equipment. This device complies with Part 15 of the 
FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause 
harmful interference, and (2) this device must accept any interference received, including 
interference that may cause undesired operation. This equipment has been tested and found to 
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These 
limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will 
not occur in a particular installation. If this equipment does cause harmful interference to radio 
or television reception, which can be determined by turning the equipment off and on, the user 
is encouraged to try to correct the interference by one or more of the following measures: 
 
 
Reorient or relocate the receiving antenna. 
 
Increase the separation between the equipment and receiver. 
 
Connect the equipment into an outlet on a circuit different from that to which the receiver 
is connected. 
 
Consult the dealer or an experienced radio/TV technician for help. 
  
 
 Quick Start Guide 
This guide assumes you know how to navigate the camera’s user interface.  All the settings 
explained in this section are in the CL MENU item.  To access the CL MENU press MODE until 
COMMANDS is selected, then press MORE until CL MENU appears, then press UP to enter.  Use 
UP and DOWN to make selections.  Press MORE to advance to the next item. 
1.  One CuddeLink equipped camera must be the HOME camera.  HOME is the camera that 
collects images from the REMOTE cameras. 
2.  Set up HOME camera: