Liftup A/S REMOTE2 Benutzerhandbuch
12
Liftup Inc. | 4809 Ehrlich Road | Suite 105 | FL – 33624, Tampa | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us
———————————— USER MANUAL – REMOTE2 – US VERSION 1.0
4.2 Pairing of remote control
Pairing of the remote control is normally done by the dealer or the factory.
1. The receiver, i.e. FlexStep must be switched off. The lift is switched on/off by activating
both the ON/OFF switch and the emergency stop
2.
Remove the front pushbutton and use a
small screwdriver to shorten the SJ2 on the
remote control* until the control LED on
the remote control* begins to flash slowly.
(If not mounted, press the S4 button which
has the same function)
3. The remote control* is now in installation mode for 2 minutes.
4. Within these 2 minutes, switch on the lift i.e. the FlexStep.
5. The control LED on the remote control* is associated with the lift when it stops flashing.
Test the system, to ensure the pairing has been performed correctly; if not, repeat steps 1.-5.
above.
*Supplementary equipment
LED
SJ2