Asrock K8 COMBO-Z K8 COMBO Z Benutzerhandbuch

Produktcode

K8 COMBO Z

2 9

BIOS SETUP UTILITY

Primary IDE Master

Select the type
of device connected
to the system.

Select Screen
Select Item

Change Option

General Help

Load Defaults

F10

Save and Exit

ESC

Exit

Advanced

Type

LBA/Large Mode
Block (Multi-Sector Transfer)
PIO Mode
DMA Mode
S . M . A . R . T .
32Bit Data Transfer

[Auto]

[Auto]
[Auto]
[Auto]
[Auto]
[Disabled]
[Disabled]

Device
Vendor
Size
LBA Mode
Block Mode
PIO Mode
Async DMA
Ultra DMA
S.M.A.R.T.

:Hard Disk
:MAXTOR 6L080J4
:80.0 GB
:Supported
:16Sectors
:4
:MultiWord DMA-2
:Ultra DMA-6
:Supported

BIOS SETUP UTILITY

IDE Configuration

Advanced

OnBoard IDE Controller

OnBoard SATA Controller

Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave

[Both]

[Enabled]

[Hard Disk]
[

]

[

]

[Not Detected]

Not Detected
ATAPI CDROM

Select Screen
Select Item

Change Option

General Help

Load Defaults

F10

Save and Exit

ESC

Exit

Select Screen
Select Item

Change Option

General Help

Load Defaults

F10

Save and Exit

ESC

Exit

DISABLED: disables the
integrated IDE
Controller.
PRIMARY: enables only
the Primary IDE
Controller.
SECONDARY: enables
only the Secondary IDE
Controller.
BOTH: enables both IDE
Controllers.

3.3.4 IDE Configuration

OnBoard IDE Controller

You may enable either the primary IDE channel or the secondary IDE channel.

Or you may enable both the primary and the secondary IDE channels by

selecting [Both]. Set to [Disabled] will disable the both. Configuration options:

[Disabled], [Primary], [Secondary], [Both].

OnBoard SATA Controller

Use this item to enable or disable the “OnBoard SATA Controller” feature.

IDE Device Configuration

You may set the IDE configuration for the device that you specify. We will

use the “Primary IDE Master” as the example in the following instruction,

which can be applied to the configurations of “Primary IDE Slave”, “Sec-

ondary IDE Master”, and “Secondary IDE Slave” as well.