Finisar 10Gb/s Laserwire, M/M, 20m, SFP+ FCBP110LD1L20S Benutzerhandbuch
Produktcode
FCBP110LD1L20S
F i n i s a r
© Finisar Corporation July 2010 Rev. B1
Page
3
III. Electrical
Characteristics
(T
OP
= 0 to 60
°C, V
CC
= 3.3 ± 5% Volts)
Parameter Symbol
Min
Typ
Max
Unit
Ref.
Supply Voltage
Vcc
3.135
3.465
V
Supply Current
Icc
150
200
mA
Link Turn-On Time
Transmit Turn-On Time
1
ms
1
Transmitter
Differential data input swing
Vin,pp
180 800
mVpp
2
Receiver
Differential data output swing
Vout,pp
450 700 850
mVpp
3
Power Supply Ripple Tolerance
PSR
33
mVpp
4
Notes:
1.
1.
From power-on and end of any fault conditions.
2.
DC coupled internally. See Figure 2 for input eye mask requirements. Self-biasing 100
Ω differential input.
Must be AC-coupled on HOST.
3.
DC Coupled with 100
Ω differential output impedance. Must be AC-coupled on HOST. See Figure 3 for
output eye mask.
4.
All transceiver specifications are guaranteed with the given power supply sinusoidal modulation up to specified
amplitude over a range of 10 Hz to 10 MHz applied through the power supply filtering network shown in Figure
6. See SFF-8431 Rev 4.2 (SFP+) specification section D.17.3 Power Supply Tolerance Testing for the test
methodology but with the module replaced by a 15 load for amplitude calibration.
amplitude over a range of 10 Hz to 10 MHz applied through the power supply filtering network shown in Figure
6. See SFF-8431 Rev 4.2 (SFP+) specification section D.17.3 Power Supply Tolerance Testing for the test
methodology but with the module replaced by a 15 load for amplitude calibration.