Finisar FTLX1341E2 Benutzerhandbuch

 

© Finisar Corporation – October 2008  

Rev B 

Page 1 

 

PRODUCT FEATURES 

ƒ  Hot pluggable X2 MSA form factor 
ƒ  Total power consumption: 4.0 W maximum 
ƒ  RoHS-6 compliant (lead-free) 
ƒ  Temperature range 0°C to 70°C 
ƒ  Transmission distance up to 220m

*

 

ƒ  Uncooled 1310 nm directly modulated  

Fabry-Perot (FP) laser 

ƒ  Built In Advanced Electronic Dispersion 

Compensation (EDC)  

ƒ  SC connector, multimode fiber  
ƒ  Full duplex transmission mode 
ƒ  Digital Optics Monitoring (DOM) 
ƒ  Power supply: +5.0 V, +3.3 V 
ƒ  Adaptable Power Supply (APS: +1.2 V) 
ƒ  XAUI electrical interface   

-  4 x 3.125 Gb/s Ethernet 

ƒ  Management and control via MDIO              

2-wire bus 

ƒ  70-pin connector 
ƒ  Separated signal/chassis ground 
ƒ  Mid Pak module variance for                    

front panel mounting 

ƒ  De-latch mechanism with low          

extraction force 

 

 

 
 
 

ƒ  IEEE 802.3aq-2006 

ƒ 

10 Gb/s Ethernet transmission on 
legacy multimode fiber.

 

The Finisar FTLX1341E2 transponder incorporates Electronic Dispersion Compensation (EDC) 
which provides correction for the severe modal dispersion that may occur during propagation 
through links up to 220m on legacy installed FDDI multimode fiber. The EDC device 
incorporates a Feed Forward Equalizer (FFE) and a Decision Feedback Equalizer (DFE).  The 
EDC also contains sophisticated clock recovery architecture for extracting a robust clock from 
extremely distorted signals. 

 

 
 
 
* Maximum reach as defined by IEEE.  Longer reach possible depending upon link implementation.