JVC TK-C215V4 Benutzerhandbuch

Seite von 32
3
I
䢇 The unit is to be powered by a DC 12 V or an 
AC 24 V power supply.
䢇 The unit is to be powered by a UL Listed DC 
12 V or an AC 24 V power supply. 
䢇 The AC 24 V and 12 V DC power supply shall 
conform to the following: Class 2 only .
䢇 This installation should be made by a qualified 
service person and should conform to all local 
codes.
䢇 This installation shall be in accordance with 
the National Electrical Code, ANSI/NFPA 70.
䢇 Any Mention in this manual of Alarm inputs  
have not been evaluated by UL to be used for 
Burglar Alarm Functionality.
䢇 Embedding of cameras in the ceiling may not 
be allowed due to regulations in some 
regions. Please consult your nearby 
authorized JVC dealer for more details.
䢇 The ceiling to mount the camera has to be 
strong enough to support the weight of this 
product. If the ceiling is not strong enough, 
make sure to apply reinforcement to the 
ceiling before installation.
䢇 Be sure to tighten the screws and nuts 
securely, Insufficient tightening may cause the 
unit to fall from its mount.
䢇 The rating label is displayed on the side of the 
camera unit.
䢇 The camera unit may fall if the mounting 
screws and nuts are not properly tightened. 
Ensure that the screws and nuts are properly 
tightened.
䢇 We do not accept liability for any damage to 
the camera in cases when it is dropped 
because of incomplete installation due to not 
observing the installation instructions 
correctly. Please be careful when installing the 
camera.
䢇 Do not install the camera near lighting 
equipment with a high temperature, such as 
spotlights. Doing so may cause malfunction or 
fire.
INFORMATION FOR USA
䡵 INFORMATION
This equipment has been tested and found to 
comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide 
reasonable protection against harmful 
interference in a residential installation. This 
equipment generates, uses, and can radiate 
radio frequency energy and, if not installed and 
used in accordance with the instructions, may 
cause harmful interference to radio 
communications. However, there is no 
guarantee that interference will not occur in a 
particular installation.
If this equipment does cause harmful 
interference to radio or television reception, 
which can be determined by turning the 
equipment off and on, the user is encouraged 
to try to correct the interference by one or more 
of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the 
equipment and receiver.
● Connect the equipment into an outlet on a 
circuit different from that to which the 
receiver is connected.
● Consult the dealer or an experienced radio/
TV technician for help.
䡵 CAUTION
CHANGES OR MODIFICATIONS NOT 
APPROVED BY JVC COULD VOID USER'S 
AUTHORITY TO OPERATE THE 
EQUIPMENT.
THIS DEVICE COMPLIES WITH PART 15 OF THE 
FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING 
TWO CONDITIONS: (1) THIS DEVICE MAY NOT 
CAUSE HARMFUL INTERFERENCE, AND (2) THIS 
DEVICE MUST ACCEPT ANY INTERFERENCE 
RECEIVED, INCLUDING INTERFERENCE THAT 
MAY CAUSE UNDESIRED OPERATION.
䢇 Before starting an important recording, be 
sure to perform a test recording in order to 
confirm that a normal recording is possible.
䢇 We will not provide any compensation 
whatsoever for the contents to be recorded or 
loss of opportunities when recording is not 
properly performed due to malfunction of the 
video camera, VTR, hard disk recorder or 
video tape.
䢇 Prior to adjusting the shooting direction of the 
camera, touch the metal surface of the 
[MONITOR] terminal with your hand to 
discharge static electricity from your body. 
TK-C215V4_V12_EN.book  Page 3  Wednesday, August 2, 2006  1:18 PM