Cisco 8GB DDR3 1600MHz UCS-MR-1X082RY-A= Benutzerhandbuch

Produktcode
UCS-MR-1X082RY-A=
Seite von 66
Cisco UCS C240 M3 High-Density Rack Server (Small Form Factor Disk Drive Model)
6
BASE SERVER STANDARD CAPABILITIES and FEATURES
BASE SERVER STANDARD CAPABILITIES and FEATURES
 lists the capabilities and features of the base server. Details about how to configure the server for 
a particular feature or capability (for example, number of processors, disk drives, or amount of memory) 
are provided in 
Table 1   Capabilities and Features 
Capability/Feature
Description
Chassis
Two rack unit (2RU) chassis
CPU
One or two Intel® E5-2600 series processor family CPUs
Chipset
Intel® C600 series chipset
Memory
24 slots for registered ECC DIMMs (RDIMMs) or load-reduced DIMMs (LRDIMMs)
NIC 
Embedded dual-port Intel i350 PCIe-based Gigabit Ethernet controller, 
supporting the following:
Pre-Execution Boot (PXE boot)
iSCSI boot
Expansion slots
Five PCIe slots (on two riser cards)
Riser 1 (PCIe slots 1, 2, and 3): 
• One x16 PCIe Gen3 Slot, x24 extended connector, full-height, 
half-length 
• Two x8 PCIe Gen3 Slots Full Height, x16 connector, half-length 
Riser 2 (PCIe slots 4 and 5): 
• One x16 PCIe Gen3 Slot, Full Height, (225W GPU Ready), x24 
connector, three-quarter length
• One x8 PCIe Gen3 Slot, half-height, x16 connector, half-length
Internal storage devices
Drives are installed into front-panel drive bays that provide hot-pluggable 
access.
Small Form Factor (SFF) drives. The server can hold up to:
• 24 2.5 inch (63.5 mm) SAS or SATA hard drives (HDDs) or solid state 
drives (SSDs) (24-drive backplane with SAS expander configuration)
• 16 2.5 inch (63.5 mm) SAS or SATA HDDs or SSDs (16-drive backplane 
with no SAS expander configuration)
The server also contains one internal USB 2.0 port on the motherboard 
that you can use with a USB thumb drive for additional storage
Cisco Flexible Flash 
drives
The server supports one internal Cisco Flexible Flash drive (SD card).
The SD card is pre-loaded with four virtual drives. The four virtual 
drives contain, respectively, the Cisco Server Configuration Utility, the 
Cisco Host Upgrade Utility, the Cisco C-Series server drivers set, and a 
blank virtual drive on which you can install an OS or a hypervisor.
4 GB is available for general use