Wi-Ex YX055-CEL Merkblatt

 

 

 
Maximum performance will be achieved when the antenna is aimed at the strongest signal from your 
wireless provider.  If you know the direction of your provider’s tower, simply point the antenna in that 
direction.  Note: the closest tower may NOT be used by your provider.  Some helpful hints are included if 
you are unsure where your tower is located. 
 

Note:  Unplug the Base Unit until all cables are connected.  Plug-in the Base Unit and 

verify that the Power light stays green and no red indicators light; otherwise, you 
may have to reorient the antenna or relocate to another location in the room.  See 
the Troubleshooting section and 

 
Installation Steps: 

1.  The highest point will usually produce the best results.  If you do not have roof access, you 

should choose the side of the building with the strongest signal.  With your wireless phone turned 
on, walk around your house while noting the number of “bars” on your signal strength indicator.   

2.  When you have determined the location of the strongest signal, install and tighten the antenna to 

your antenna mast or pole with the brackets provided.  Loosely tighten the mast, so that you can 
rotate it from the base. 

3.  Connect the RG-6 coax cable to the antenna. 
4.  Wrap the F- type connector using the Coax-Seal tape provided in the package. 
5.  Route the antenna cable indoors and connect it to the base unit using the Cell Phone Signal 

Booster installation instructions. 

 

Rev. 20070227