Minute Man LineGuard MMS-PTZ-UTP Merkblatt
Produktcode
MMS-PTZ-UTP
Para Systems, Inc. • 800.238.7272• 1455 LeMay Dr. • Carrollton, Texas 75007 U.S.A.
www.minutemanups.com • www.sizemyups.com • www.sizemypdu.com • www.comparemyups.com
LineGuard
™
Surge Suppressors
for data line protection
P
rotection
for
D
ata
L
ines
Electrical transients can cause equipment to
malfunction and can even have a catastrophic
effect, inflicting severe damage to expensive
devices, some of which may be mission critical.
These electrical disturbances can enter into a
network system through data lines that create a
“back door” entrance to equipment. Normally,
these electrical lines transmit data via very low
voltage signals between devices, and by their very
nature, data cables can have a direct route into
equipment when higher voltage transients find their
way onto data lines. Such damaging transients
include electrostatic discharge, electromagnetic
interference, and the most devastating of them all,
lightning.
When damage to expensive equipment does
occur from these types of anomalies, it is not
covered under a manufacturer’s warranty. When
you compare the cost of downtime and equipment
replacement costs, these surge suppressors are an
excellent investment.
Minuteman’s LineGuard products are UL listed
and designed for fast, simple installation. All models
are covered under Minuteman’s limited lifetime
warranty, along with a $10,000 attached equipment
protection plan.
f
eatures
Solid-state, nanosecond response to over-
voltage surges
voltage surges
Lightning rated
UL 497B listed
Limited lifetime warranty
$10,000 attached equipment protection
Interlocking wall-mount with single ground
Fast, easy installation
•
•
•
•
•
•
•
•
•
•
•
•
minutemanups.com/lineguard
MMS-PTZ-BAL
Designed for analog cameras
Uses UTP to BNC connector for video
Built-in balun Terminal block for power
(2 wires) and 4 wires for controls
MMS-PTZ-UTP
Designed for analog cameras
Uses UTP to UTP for video
Terminal block for power (2 wires)
and 4 wires for controls
MMS-PTZ-BNC
Designed for analog cameras Uses
BNC connector for video
Terminal block for power (2 wires)
and 4 wires for controls
MMS-CAT5-LAN-RJ45
Designed for CAT5 data lines
Uses RJ-45 connectors
For LAN network protection
IP cameras
MMS-CAT5-POE-RJ45
Designed for CAT5 LAN/POE lines
Uses RJ-45 connectors
For LAN and POE protection
IP cameras
Not stocked, special order
MMS-CAT6-LAN
Designed for CAT6 data lines
Uses punch-down block
For LAN network protection
IP cameras
Not stocked, special order
MMS-CAT6-POE
Designed for CAT6 LAN/POE lines
Uses punch-down block
For LAN and POE protection
IP cameras
Will work with CAT5 POE