Transition Networks E-CX-MC02 Benutzerhandbuch

n e t w o r k s

T R A N S I T I O N

The TRANSITION Networks Ethernet™ Coaxial Transceiver (E-CX-MC02, E-CX-MC03,
E-CX-MC04, or E-CX-MC05) is  designed to provide connection between the Thick
(10Base5) or Thin (10Base2) coaxial Ethernet environment and a PC or hub with an
AUI connector.

FCC Regulations:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed  to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own cost.

NOTE:

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out
on the radio interference regulations of the Canadian Department of Communications.

NOTE:

This equipment has been tested and found to comply with VDE Class B requirements.

For selling in the Federal Republic of Germany: 

Hiermit wird bescheinigt, das der E-FRL-MC01 oder E-FRL-MC01(SMA) in Ubereinstimmung mit den
Bestimmungen der Vfg. 243/1991 funk-entstoert ist. Der Deutschen Bundespost wurde das
Inverkehgringen dieses Geraetes angezeigt und die Berechtigung zur Ueberpruefung der Serie auf
Einhaltung der Bestimmungen eingeraumt. TRANSITION Networks, Inc.

Canadian Regulations:
Note: This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the
radio interference regulations of the Canadian Department of Communications.

Copyright Restrictions
©  1995 Transition Networks, Inc.
All rights reserved.  No part of this work may be reproduced or used in any form or by any means - graphic,
electronic, or mechanical - without written permission from Transition Networks, Inc.

Trademarks:
Ethernet is a registered trademark of the Xerox Corporation, Inc.
ST is a trademark of AT&T.
TRANSITION Networks and Micro-Ceiver are trademarks of TRANSITION Networks

7315 E

Case size dimensions:

3.5" x 3.75" x 1.25" 

(89 mm x 95 mm x 32 mm)

AUI Port:

Male DB-15 with locking posts.

AUI Connection:

Use only an IEEE 802.3 equivalent AUI
cable.  

Connector Legend: 

1

Logic Ref.

9

Collision-

2

Collision+

10 Transmit-

3

Transmit+

11 Logic Ref.

4

Logic Ref.

12 Receive-

5

Receive+

13 Power

6

Power Return

14 Logic Ref.

7

N/C

15 N/C

8

Logic Ref.

AUI Drop Cable Maximum Distance:

50 meters (165 feet)

10Base5 Cable Maximum Distance:

500 meters (1640 feet)

10Base2 Cable Maximum Distance:

185 meters (610 feet)

Environment:

0–50 degrees C,
10–90% humidity, non-condensing,
0–10,000 foot altitude

Warranty:

Five years

Minneapolis, MN  55344  USA

Status LEDs on the Ethernet Coaxial Transceiver provide the following
information:

The TRANSITION Networks Ethernet™ Coaxial Transceiver part numbers indicate
the AMP tap that is shipped with the Coaxial Transceiver:

with AMP non-intrusive tap

228752-1

with AMP N-Series intrusive tap,

221914-1 

with AMP BNC-T connector

221918-1

with AMP BNC vertical adapter

222455-1

All Ethernet™ Coaxial Transceivers provide a male AUI connector.

Illuminated green LED indicates power through the
AUI connector.

Illuminated green LED indicates the SQE jumper is set
to ON.