Tricity Bendix MDB700 Benutzerhandbuch
10
HOW TO FINISH UNPACKING
·
Place appliance next to the space in which it will
be installed. See Fig 8.
be installed. See Fig 8.
·
Remove the appliance packing except for bottom
tray which should be left in position until the
appliance is ready to be fitted into its cabinet.
tray which should be left in position until the
appliance is ready to be fitted into its cabinet.
·
Ensure the owner is given these operating
instructions.
instructions.
NOTE: It is imperative that the appliance is left in
the base to protect both the appliance and the
floor.
the base to protect both the appliance and the
floor.
Important: Switch off at mains, miniature
circuit breaker and, if appropriate, remove
fuse before commencing any electrical
work.
circuit breaker and, if appropriate, remove
fuse before commencing any electrical
work.
TO REMOVE COVER OF MAINS
TERMINAL
TERMINAL
From the rear of the appliance, remove mains input
terminal cover to gain access to terminal block.
terminal cover to gain access to terminal block.
·
First remove retaining screw with pozidrive
screwdriver. See Fig. 9.
screwdriver. See Fig. 9.
·
Prise cover loose using screwdriver in position
(1) then lever off with screwdriver in position (2)
at either side. See Fig. 10.
(1) then lever off with screwdriver in position (2)
at either side. See Fig. 10.
·
Lift cover and remove screw from cable clamp.
See Fig. 11.
See Fig. 11.
Fig. 8
Fig. 9
Fig. 10
Fig.11