Tricity Bendix MDB700 Benutzerhandbuch

If the door glass panel becomes chipped or
has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
Please contact your local Service Force
Centre who will be pleased to advise
further.

REPLACE THE OUTER DOOR GLASS

1. Holding the oven glass with both hands, gently

place the locators into the holes of the brackets
at the bottom of the oven door.

2. Holding the door glass with your left hand, use

your right hand to open the oven door.
Bring the door gently towards the glass panel
ensuring the screw location holes line up.

3. Place the trim in the correct position on the top of

the grill door.

4. Hold the glass in place with one hand and insert

the cross head screws with washers into the
location holes with the other hand. Give the
screws one turn to ensure the glass is secure.

5. Tighten the screws positively with a Pozidrive

screwdriver before closing the oven door.

DO NOT attempt to use the oven without
the glass being in place.

CLEANING THE INNER GLASS DOOR

The inner glass door is not removable. Clean using
hot soapy water or Hob Brite and a soft cloth. DO
NOT use abrasives as they may damage the glass or
seal.

CLEANING INSIDE THE OVEN AND GRILL
COMPARTMENTS

The Stayclean surface on the rear oven panel in the
fan oven should not be cleaned manually.

The vitreous enamel in the grill compartment and the
fan oven base and sides can be cleaned using
normal oven cleaners with care. Ensure that the
manufacturers instructions are followed and that all
parts are well rinsed afterwards.

Aerosol cleaners must not be used on the
Stayclean rear oven panel and must not come
into contact with elements or the door deal as
this may cause damage.

During normal use the Stayclean coating will become
splashed with fats and food residues. By running the
oven without food, the Stayclean surfaces burn off
any soilage.

TO REMOVE THE WIREWORK RUNNERS

The wirework runners in the grill and oven
cavities can be removed for cleaning.

1. Remove all shelves and furniture from the grill

and oven compartments.

2. Hold the wirework at the bottom, unclip from the

cavity side and gently pull towards the centre of
the grill or oven compartment.

3. Unhook the runner at the top and remove from

the cavity.

4. To replace, hook the wirework runner back into

the grill/oven sides.

Ensure that the wirework runners are firmly
in place before refitting the oven shelves.

CLEANING THE SHELVES, WIREWORK
RUNNERS AND GRILL/OVEN FURNITURE

All removable parts, except the grill pan handle can
be washed in the dishwasher.

The grill pan, grill pan grid, oven shelves and
wirework runners may be cleaned using a soap
impregnated steel wool pad. Soaking first in hot
soapy water will make cleaning easier.

CAVITY
CENTRE

SIDE PANEL