Troy-Bilt 77T Benutzerhandbuch

NOTE: This unit may have been shipped with the 
battery cables already connected.  If not, follow the 
instructions below for attaching the battery cables.

NOTE: The positive battery terminal is marked Pos. (+). 
The negative battery terminal is marked Neg. (–).
•  The positive cable (heavy red wire) is secured to the 

positive battery terminal (+) with a hex bolt and hex 
nut at the factory. Make certain that the rubber boot 
covers the terminal to help protect it from corrosion.

•  Remove the hex bolt and hex nut from the negative 

cable. 

•  Remove the black plastic cover, if present, from the 

negative battery terminal and attach the negative 
cable (heavy black wire) to the negative battery 
terminal (–) with the bolt and nut.

•  Make certain the hold-down strap is in position over 

the battery, securing it in place. See Figure 1.

NOTE: If the battery is put into service after the date 
shown on top of battery, charge the battery as instructed 
on page 20 of this manual prior to operating the tractor.

The gasoline tank is located under the hood and has a 
capacity of 1-1/2 gallons. Do not overfill. 

Service the engine with gasoline and oil as instructed in 
the separate Engine Operator/Owner’s Manual packed 
with your tractor. Read instructions carefully.

IMPORTANT: Your tractor is shipped with motor oil 
in the engine. However, you MUST check the oil level 
before operating. Be careful not to overfill.

•  Locate the shipping brace, if present, and accom-

panying warning tag found on the right side of the 
mower, between the discharge chute and the cutting 
deck. See Figure 2.

•  While holding the discharge chute with your left hand, 

remove the shipping brace with your right hand by 
grasping it between your thumb and index finger and 
rotating it clockwise.

�����������

��������

��������