Troy-Bilt 830 Benutzerhandbuch

1.  Remove any packing material which may be between 

upper and lower handles. 
a.  Pull up and back on upper handle as shown in 

Figure 3-1. Do not crimp cable while lifting the 
handle up. Remove star knobs from handle mount-
ing brackets and secure the lower handle onto the 
handle brackets by placing the lower hole of the 
lower handle onto the pins of the handle brackets.

b.  Tighten star knobs securing upper handle to lower 

handle. See Figure 3-1. Make sure that each 
carriage bolt is seated properly in the handle.

2.  Tighten star knobs securing lower handle to handle 

brackets. See Figure 3-2. Make certain the lower 
handle is seated securely into the handle mounting 
brackets.

3.  The rope guide is attached to the right side of the 

upper handle. Loosen the wing nut which secures the 
rope guide. See Figure 3-3.
a.  Hold the blade control against upper handle. 
b.  Pull starter rope out of the engine. Release the 

blade control. 

c.  Slip starter rope into rope guide. 
d.  Tighten wing nut.

4.  Secure cables to the lower handle using the cable tie.

Pull cable tie tight and cut off excess.

5.  To assemble the grass catcher (if needed), place bag 

over frame with the black plastic side at the bottom. 
Slip plastic channel over hooks on frame. All channels 
except for center top of bag attach from the outside. 
The center of bag attaches from the inside.

6.  Before attaching the grass catcher, the mulching 

baffle must be removed. Refer to Figure 3-5.
a.  Lift rear discharge door.
b.  Remove mulching baffle.

7.  To attach grass catcher, refer to Figure 3-4.

a.  Lift rear discharge door.

NOTE: Stand behind 
the mower as if you 
were going to operate 
it. Your right hand cor-
responds to the right 
side of the mower; your 
left hand corresponds 
to the left side of the 
mower.

NOTE: For shipping 
purposes your mower 
is set with the wheels 
in a low cutting height 
position. For best 
results raise the cutting 
position until it is deter-
mined which height is 
best for your lawn, refer 
to Adjustment section 
for instructions.

DO NOT crimp the 
cables when lifting the 
handle up.

Figure 3-1: Unfold handle and tighten hardware. 

Figure 3-2: Secure handle to handle mounting brackets.

Figure 3-3: Pull recoil starter through rope guide and tighten.

Figure 3-4: Lift discharge door and place grass catcher on rod.

NOTE: This Operator’s 

Manual covers several 

models. Lawn Mower 

features vary by 

model. Not all features 

discussed (or engines 

pictured) in this manual 

are applicable to all 

Lawn Mower models.

Handle Mounting Bracket