Troy-Bilt 1942/2246/2350/2454 Benutzerhandbuch

3. 

Carefully remove the belt from around the idler pulleys and 

the spindle pulleys.

Avoid pinching injuries. Never place 

your fingers on the idler spring or between the belt 

and a pulley while removing the belt. 

4. 

Route the new belt as shown in the applicable figure on 

the following pages. See Figure 7-8 for 42” decks, Figure 7-9 

for 46” decks and Figure 7-10 for 50” & 54” decks.

NOTE: Use a ¹/2-inch drive ratchet wrench as instructed in 

earlier steps when routing the new belt.

5. 

Retighten idler pulleys, if loosened earlier.

6. 

Remount the spindle covers if removed earlier.

7. 

Re-install the deck making sure the belt remains routed 

around the pulleys as instructed.

8. 

On manual PTO units, re-install the engine pulley keeper 

rod and the PTO cable.

9. 

Pull the right side of the belt and place the narrow V side of 

the belt into the  PTO pulley. See Figure 7-11.

10.  While holding the belt and pulley together, rotate the 

pulley to the left. Continue holding and rotating the pulley 

and belt until the belt is fully rolled into the PTO pulley.

Several components must be removed and special tools used in 

order to change the tractor’s transmission drive belt. See your 

authorized dealer to have the transmission drive belt replaced.