Troy-Bilt RZT Benutzerhandbuch

1. 

Using the deck lift handle, raise the deck to the  position that 

provides the most horizontal run of the belt between the deck 

idler pulleys and the PTO pulley on the bottom of the engine.

2. 

Sitting behind the tractor facing forward, reach beneath 

the tractor to grasp the belt at the front of the PTO pulley.

Use caution to avoid pinching your 

fingers when rolling the belt off the PTO pulley.

3. 

Pull the left side of the belt rearward and downward while 

manually turning the PTO pulley to the right until the belt 

rides out onto the edge of the lower sheave of the pulley.
NOTE: If pulling the right side of the belt, turn the pulley left.

4. 

While still holding the belt downward, continue turning the 

PTO pulley until the belt is rolled off the pulley. Refer to Figure 

7-5.

5. 

Lower the deck into the lowest position using the deck lift 

handle. See Figure 7-3.

1. 

Using the deck lift handle, raise the deck to the  position 

that provides the most horizontal run of the belt between 

the deck idler pulleys and the PTO pulley on the bottom of 

the engine. See Figure 7-3.

2. 

Working from the middle of the tractor, pivot the idler 

bracket and movable idler pulley rearward away from the 

backside of the ‘V” belt just far enough to lift the belt up 

and over the idler pulley. See Figure 7-4.

3. 

From beneath the rear of the tractor, slide the belt off of 

the PTO pulley on the bottom of the engine.