Troy-Bilt RZT Benutzerhandbuch

4. 

Remove the belt from the spindle pulleys.

5. 

Install the new belt around the spindle pulleys as shown  

and reinstall the belt covers. See Figure 7-10.

6. 

Place the belt around the idler pulleys removed in step 3 

with the “V” side facing in. Once in place, reinstall all the 

hardware and tighten the flange lock nut to secure the 

assembly. See Figure 7-11.

7. 

Route the belt as shown in Figure 7-11 and then reinstall 

the deck (refer to Deck Installation on page 29).

1. 

Remove the deck from beneath the tractor, (refer to Deck 

Removal on page 27).

2. 

Remove the hex washer screws securing the belt covers to 

the deck. See Figure 7-12.

3. 

Remove the two idler pulleys by removing the hex screws 

and flange lock nuts that secure them to the deck and the 

idler arm. See Figure 7-13. Do not lose any of the hardware 

when removing the hex screw and flange lock nut.

NOTE: Take note of the position of the belt guards to 

ensure they are properly re-installed.

4. 

Remove the belt from the spindle pulleys.

5. 

Install the new belt around the spindle pulleys as shown  

and reinstall the belt covers. See Figure 7-12.

6. 

Place the belt around the idler pulleys removed in step 3 

with the “V” side facing in. Once in place, reinstall all the 

hardware and tighten the flange lock nut to secure the 

assembly. See Figure 7-13.

7. 

Route the belt as shown in Figure 7-13 and then reinstall 

the deck (refer to Deck Installation on page 29).