Troy-Bilt TB210 Benutzerhandbuch

Your mower’s deck may be equipped with a water port on its 
surface as part of its deck wash system. Use the deck wash to 
rinse grass clippings from the deck’s underside.

Your mower is shipped as a mulcher. To discharge the grass 
clippings to the side instead, follow the instructions in the 
“Assembly & Set-Up” section to attach the side discharge chute.

Keep hands and feet away from the 

chute area on cutting deck. Refer to warning label 
on the unit.

The recoil starter is attached to the right upper handle. Stand 
behind the unit and pull the recoil starter rope to start the unit.

The electric start ignition switch is located on the right side of 
the upper handle. It is used only for the electric starter.

The blade control is attached to the upper handle of the mower. 
Depress and squeeze it against the upper handle to operate the 
unit. Release it to stop engine and blade.

This blade control is a safety device. 

Never attempt to bypass its operations.

The drive control is located on the underside of the upper handle 
and is used to engage the drive. Squeeze it against the upper 
handle to engage the drive; release it to slow down or stop 
mower from propelling.

One adjustment lever is located on the right rear wheel and one 
is located on the right front wheel. Both levers have to be at the 
same relative position to ensure a uniform cut. To adjust the 
cutting height, refer to the “Assembly & Set-Up” Section.