Troy-Bilt TB210 Benutzerhandbuch

The battery contains corrosive fluid 

and toxic material; handle with care and keep away 
from children. Do not puncture, disassemble, 
mutilate or incinerate the battery. Explosive gases 
could be vented during charging or discharging. Use 
in a well ventilated area, away from sources of 
ignition.

NOTE: The special designed plug on the charger will only fit into 
the plug on the battery box.

Unhinge the cover seal and plug the battery charger into 

1. 

the port on the side of the battery housing. See Fig. 7-4.

Insert the battery charger plug into a standard 120 volt 

2. 

household outlet. Charge battery for 8 to 10 hours before 
initial use. Do not charge longer than 12 hours. The battery 
should only need to be charged upon initial setup, at the 
end of the season, after any other extended periods of 
non-use, and as needed.
NOTE: If you frequently stop and restart the mower 
during each cut throughout the season (for instance when 
bagging), more frequent charging may be necessary.
After charging, disconnect charger plug from outlet first, 

3. 

then disconnect charger lead from battery and reattach 
cover seal.
IMPORTANT: Do not remove the battery pack from 
the electric starter housing for any reason other than 
replacement.
IMPORTANT: Always plug charger lead into battery pack 
lead first, and then insert battery charger plug into 120 
volt standard household outlet. Follow this order of action 
every time you charge the battery.

Batteries contain sulfuric acid which 

may cause burns. Do not short circuit or mutilate 
batteries in any way. Do not put batteries in fire as 
these may burst or release toxic materials.

Unhinge cover seal and lift off battery cover.

1. 

Remove positive and negative leads from battery, and pull 

2. 

up on battery to remove.  See Fig. 7-2.

Replace with new battery. Connect the positive lead (red) to the 

3. 

positive side of the battery pack, then connect the negative 
lead (black) to the negative side. See Fig. 7-3.

Reattach battery cover and cover seal.

4.