Troy-Bilt TB2450 Benutzerhandbuch

3. 

Attach the hose coupler to the water port on your decks 

surface. See Figure 6-2.

4. 

Turn the water on.

5. 

While sitting in the operator’s position on the tractor, start 

the engine and place the throttle lever in the FAST (rabbit) 

position.

6. 

Move the tractor’s PTO (Blade Engage) into the ON position.

7. 

Remain in the operator’s position with the cutting deck 

engaged for a minimum of two minutes, allowing the 

underside of the cutting deck to thoroughly rinse.

8. 

Move the tractor’s PTO (Blade Engage) into the OFF 

position.

9. 

Turn the ignition key to the STOP position to turn the 

tractor’s engine off.

10.  Turn the water off and detach the hose coupler from the 

water port on your deck’s surface.

11.  Repeat step 4- step 11 on the opposite side of the cutting 

deck.

After cleaning your deck with the deck wash system, return to 

the operator’s position and engage the PTO. Keep the cutting 

deck running for a minimum of two minutes, allowing the 

underside of the cutting deck to thoroughly dry.

Before lubricating, repairing, or 

inspecting, always disengage PTO, set parking 

brake, stop engine and remove key to prevent 

unintended starting.

Each of the front wheel axles and rims is equipped with a grease 

fitting. See Figure 6-3. Lubricate with a No. 2 multi-purpose 

grease applied with a grease gun after every 25 hours of tractor 

operation.

Lubricate all the pivot points on the drive system, parking brake 

and lift linkage at least once a season with light oil.

Each of the tractor deck’s front gauge wheels is equipped with 

a grease fitting. Lubricate with a No. 2 multi-purpose grease 

applied with a grease gun after every 25 hours of tractor 

operation