Troy-Bilt TB280ES Benutzerhandbuch

The blade control is attached to the upper handle of the mower. 

Depress and squeeze it against the upper handle to operate the 

unit. Release it to stop engine and blade.

This blade control is a safety device. 

Never attempt to bypass its operations.

The drive control is located on top of the upper handle and is 

used to engage the drive. Squeeze it against the upper handle 

to engage the drive; release it to slow down or stop mower from 

propelling.

One adjustment lever is located on the right rear wheel and one 

is located on the right front wheel. Both levers have to be at the 

same relative position to ensure a uniform cut. To adjust the 

cutting height, refer to the “Assembly & Set-Up” Section.

Your mower’s deck is equipped with a water port on its surface 

as part of its deck wash system. Use the deck wash to rinse grass 

clippings from the deck’s underside.

Your mower is shipped as a mulcher. To discharge the grass 

clippings to the side instead, follow the instructions in the 

“Assembly & Set-Up” section to attach the side discharge chute.

Keep hands and feet away from the 

chute area on cutting deck. Refer to warning label 

on the unit.

The recoil starter is attached to the right upper handle. Stand 

behind the unit and pull the recoil starter rope to start the unit.

The electric start ignition switch is located on the right side of 

the upper handle. It is used only for the electric starter.