Troy-Bilt 1400 Benutzerhandbuch

3. 

Pull the belt off Pulley B. 

4. 

Replace in the opposite order. 

See your authorized service dealer to have the cogged belt 

replaced or phone Customer Support as instructed on page 2 for 

information on ordering a Service Manual.

The snow thrower auger’s rubber paddles are subject to wear 

and should be replaced if any signs of excessive wear are present.
1. 

Remove the existing rubber paddles by unthreading the 

hex washer screws and nuts that secure them to the auger. 

See Figure 7-4.

2. 

Secure the replacement rubber paddles to the auger using 

the hardware removed earlier.

1. 

Unscrew the screws on each side of the wheel shaft. See 

Figure 7-5.
NOTE: It may help to use a clamp to hold the wheel shaft in 

place while removing the screws.

2. 

Replace the roller wheels with the hardware removed 

earlier.